Anyone have any good pictures their replacement floors? Especially where the floor meets the tunnel area. Trying to deceide the best way to mate...
We started in the middle. We marked out the beads using a sharpie so we had a big line to follow then would roll from one end to the other...
Actually panel did "oil can" a bit. I will install the new hat channels then lay the new panel in the floor and then put sand bags, brake drums...
Ok center to center bead dims are 4" and basically it is 36" from inside FW to FW. New floor from a distance not too bad looking. [IMG]...
I actually rolled mine last night! My orginal floor had 7/8 to 15/16 wide beads and they are rounded. We only had a 5/8 roller bead and it was...
Ok got them. I got out the BFH and they fell right out. I did shoot them up with PB and let them sit all night so that might have helped out also.
Ok I had a great idea of looking at the new part.R) So I have a better understanding of how the seat sits on the BJ. It has a slit in the seat...
Yeah thats the way I read it but I dont understand if the ball joint stud is threaded and the yoke is threaded and the ball joint seat is threaded...
????????? Huh? So that nut down inside the yoke in the last picture has to come out first or it does not matter? Yes that is the top ball joint.
Ok so is this correct? Does not seem to be moving any. [IMG] [IMG] We are sure this nut inside the top of the yoke does not need to come...
So once you have the spindles off, axles out nuts loose you just take the ball joint seperator and hammer into place until the ball joits...
Ok thanks Nick. I did not really pay attention to the center hole as I was just holding it up against the backing plate looking at the mounting...
Did you ever get a chance to get a picture of this? Also when using the 11" front plates I notice not all the holes line up with my Dana 44...
Ok, I acutall found the service manual last night on oljeep.com. It says to press the bearing retainer and bearing on at the same time. But I...
Cut off wheel and chisel was the ticket. Thanks. Ok whats the best way to get them back on? I guess a shop/floor press and let the axle stub...
I have searced for this information but cannot find anything. Can someone help? What is the best way to get the bearing retaining ring off the...
Looks similiar. Is that powder coat or paint? Looks good. I am re-building my axles right now as well and hope to get a rolling chasis by early...
Got the frame and some pieces back from powder coat. Frame upside down. [IMG] [IMG] Skid Plate [IMG] Trans/TC crossmember, seat brackets...
That looks very practical. I have that exact winch but have never used it. It looked to me like they had tried to wind the bumper up on mine...
Rear floor is out. Anyone have good a inexpensive source for floor material? My plan was to leave the 3/4 inch lip around the edges drill holes...
Separate names with a comma.