I'd try electrolytic rust removal. Fill the cylinders with a solution consisting of 1Tbsp "Washing soda"(Not baking soda) to 1 gallon water. Hook...
If you're talking about the engine stay cable (Look at http://www.cj3a.info/tech/stay.html) Should deflect 1/2" under "thumb pressure".
Thanks napaguy, The trouble spots I've listed are all I found on a careful survey of the entire frame. The front 60% of the frame was protected...
Getting ready to wire wheel and paint the frame on my cj5 I've gone around the frame and run across a couple of damaged areas that might or might...
Yup, on closer inspection today, turns out that's part of the part #CJP 740 A 10W.
While pulling the engine off my '64 cj5 (ALL RIGHT! down to the frame!) I noticed the Prestone Generator on my F-head listed 10W as it's output...
Sorry to revive an old thread, just wanted to point out an updated link for Howard's WhirlyJig as the old link is broken. Thought this might help...
Like W3SRL said velocity. It supports turbulence and better mixing. You don't want turbulence on the exhaust path but on the intake any mixing...
If this isn't the correct place please move me mods. My '64 is getting a D30 with 1-1/8" thick rotors (which I picked up for a $Jackson :))....
I bet the two upper holes might be enough. You're welcome, no problem!:stout:
Actually, now that I think about it..... The idle mixture screw is probably what you want. It's at the base of the carb under the choke. If you...
Checked your float level?
On my '64 CJ5 Here's a pic of the Firewall side of my Oil Bath aircleaner: [IMG] Here's a pic of the firewall mounting holes: [IMG] The...
I have used Novus on Quad plastic and helmet shields. Works well...You'd probably want the #3 for your application. I hear basic no frills...
Welcome! That looks like a fine Jeep! That front roll bar mount scares me though! :eek: But...I'm one to talk, I don't even have a rollbar. R)
Engine Ground?
Had a 93 4-door with vortec heads and TBI.
If the D44 still has the tag look for 47 / 11. Otherwise if you count the ring gear will have 47 teeth and the pinion 11. It i my...
First of all.... Thanks everybody for your input. I figured now is the time for major work while I tear it down to the bare frame in my...
Don't wanna thread-jack.... How do you protect a closed space you're gonna weld over??
Separate names with a comma.