Another plug for Pertronix; although not on either of my Jeeps - yet. I had a 69 Bronco I got cheap off a buddy of mine, and even after a...
Got mine from New Life Canvas a few years ago. You might try giving them a call. Here is the link to their site:...
That sure is one sweet, clean jeep. Awesome!
Had one made for my 3B by New Life Canvas two years ago. Bit over $100 shipped at the time. They were a little tough to get ahold of, but did...
The pin fell out when I removed the front bearing retainer from the case. I knew that something fell but didn't know what until the instructions...
Ziplock bag inside a canvass tool bag kept in the tool box under the passenger seat. I keep a lock on the tool box - don't need jacks and tools...
I also got 52-1/4" wide on a 3B windshield frame. The top is slightly curved. BTW - I'm in the exact opposite position of you - I have a...
Hey guys, I'm cleaning out some stuff out from my rebuild. During my quest for parts for my 3B, I believe that I bought a CJ5 rear drive...
What an awesome project. I can't wait to see your progress on it. It will totally rock when its finished.
Awesome rig. It looks like whoever did the mods on it, did a nice job, unlike whoever did the mods on mine :cry:
From what I've seen, Walck's seems to usually have about the best prices and I've never had any problems with them. I also buy from Krage...
Don't know if you've seen this or not, but here is a link to an article on the CJ3B Page. Scroll about half way down the page to the fuel pump...
Here is a link to some info over on the CJ3B Page: http://www.film.queensu.ca/CJ3B/Tech/LowHoodFHead.html Good luck, Doug
I didn't purchase a wiring harness, I bought spools of wire and ran one at a time. I did put in a fuse panel (it's kinda cheap, came with a parts...
Check out Pertronix. They make a module that will replace the points. I don't have one myself, but was thinking on getting one....
Wendell, I will ALWAYS say keep it stock. Personally, I think that 60 is too fast for the old flatties. With 50-60 year old parts in there, who...
Separate names with a comma.