I would just like someone to confirm that this is large hole and I can use it? I mainly, am interested in the case. Thanks Jason
Arrived yesterday evening... [img]
I now have headers so I will not need the manifolds. The passenger side is a factory, no cracks. The drivers is a rear dump off of a newer V6....
I am putting disc brakes on the rear 44 (flanged) Everything is straight forward, but there is an issue with on bolt that does not clear. One of...
In the Fort Worth area, doesn't look too bad, for $125. https://www.facebook.com/marketplace/item/603482988374491/?mibextid=dXMIcH
I failed to mark my motor mounts when I removed them, how does one tell which is driver from passenger?
I needed this long ago! Now I am looking for stuff to cut!(y)(y):bananatool: (I never thought I would use that annoying banana)
I currently have a Turbo 400 in my CJ6. I would like to get the lower 1st gear plus the overdrive. The tolerances are tight with the front drive...
Any of our Canadian brothers have access to this? I like this, since it doesn't have the idiot light. ABCO Distributors
Ok, I need some tech advice for my brakes on the 71. I swapped the axles and hooked up the brake lines bled the brakes and all seemed well....
My passenger seat bracket is fubar and I need ideas for an easy and efficient mount. Thanks!
Well, this is what I started with, a 2012 JKU Call Of Duty (Rubicon). Got a good deal on it so...It has gone through some changes this past year....
The 6 made it to it's new home. Actually, got to Moab! Tucked in for now. [IMG] [IMG] [IMG]
As if I don't have enough to finish, I had to save this little ol' thing... [IMG][img]
Ok, I got the EZ wire 21 circuit system. The connections that they have pre-installed, what type of ignition switch does it match? Or do I...
On the Dauntless where is the oil pressure port, so I can hook up my sender? Thanks in advance, Jason
I've spent some time reading on the new wiring. For those that have used the EZ wire kits, this is the one I'm thinking of going with, EZ Wiring...
This is what is done.... HEI installed, carb rebuilt by Guaranteed Carbs. Issue's: Start up runs smooth as silk, timing set at 8 BTDC, RPM at...
Ok, since I have to pull the transmission and transfer case, I'm thinking I might as well upgrade to a 4spd and dump the T-14. What pieces and...
[IMG]
Separate names with a comma.