Got it finally. The portion of the points that help load the pressure which is secure with the condenser plate was not inserted therefore it was...
Do coils just up and die or do they progressively get worse until the ignition system eventually get no spark?
My '47 L134 had started backfiring through the carb and it progressively worsened, unbenounced to me (it's my 16 year old's daily driver) it also...
I have two gallon of the GL1, any any reason not to use GL1?
Service manual recommends changing every 2,000 miles? Find it tough to believe there is no practical way to drain the old fluid out? Check that;...
Transmission fluid and transfer case for my CJ2a; GL1 90 weight or GL3, GL4, GL5 90 weight? Am I splitting hairs for nothing? Thanks for any...
How do I drain out the old fluid?
Just looking for some clairity Working on getting the proper ground for a fuel gauge. I understand the gauge needs grounded but also am I to...
Does the rubber bellows boot go over the thicker piece in the center of the push rod or only up to this peice around the thin portion or the rod?...
That's what I presumed. Perfect, thank you.
Single chamber master cylinder on a 67 CJ5 w/ a F134. Does the plunder end of the push rod just sit inside the MC? What holds it into the MC?...
How legal is it driving with the windshield down?
Bad lighting, they are actually black.
So more pictures of the 2A [IMG] [IMG] [IMG] [IMG]
A coworker mentioned it while I was traveling on business in Minnesota, he had no idea the year though. Looking for a tub for my '67 I went to...
Well I took your advise (kinda) and bought a daily driver for some instant gratification. Not a YJ, but a '47 CJ2A, and lots of fun to drive....
Interesting, so should I go with a one piece tie rod from left knuckle to the second hole on the two hole knuckle and another shorter tie rod from...
So per everyones advise I've got F134 started, got it to run, about to get it to stop (just waiting on some master cylinder parts from the rude...
Found it, under years of history mostly rust that needed sanded. It was right where all of you said it would be, adjacent to the starter, at the...
Thanks, I did figure that out being battery trays are different for the 6 cylinders and 4 cylinders. Still haven't found the stamping yet though,...
Separate names with a comma.