67CJ5 f134 Noticed a leak coming from the rear of the oil pan while running...couple of drops every few minutes. PO had engine rebuilt so I...
noticed that the oil pressure on my 67 F134 is higher than it used to be. At idle (warm) we used to sit at about 10 psi, now closer to 20. at 45...
[ATTACH] [ATTACH] see photos. I just finished lubing everything that had a zert fitting but the manual calls for lubricating the front axle and...
I am going to install a 35 watt white light on the rear bumper of my 67 CJ5. I will control with a simple toggle switch on the dash. Can I wire...
I'm getting ready to install a Mojave 640 after market heater in 67 CJ5 with F134. There is no fuse box on this jeep, only inline fuses and fuse...
I can't get this nut holding the pinon seal on the shafloosened for the life of me. had an impact wrench on it and she won't budge. Now I'm...
I installed a new steering wheel this weekend on my 67 cj5 w f134. While the steering shaft was open it was also time to install a horn as one...
There is a cone shaped screen filter inside the side valve cover of my f134 on a 67 CJ5. It is held in place by the front bolt on the cover....
Had some knocking going on so decided to adjust intake and exhaust tappets/valves last weekend. Went through the whole procedure (you tube...
trying to get this nut loose and she won't give. I've got the yoke stabilized so it won't turn but even with an impact wrench with 1 and 1/8...
1967 cj 5. While disconnecting the front drive shaft to be able to replace the front piñon gear seal, I figured I would remove the u joint and...
What's the best way to hold the front drive shaft still so I can losen the nuts on the spindle yoke? With front drive disengaged the shaft just...
Read several threads but can't find a definitive answer on whether WARN lockout hubs have to be removed or not to get drums off? If they have to...
67 cj5 with F134. Replaced starter solenoid a few months ago. Ever since Now and then as I am cranking there is a horrible mashing of teeth...
A couple of weeks ago hopped in the jeep for a weekend ride and battery was about dead. Got jumped and went to local auto parts store. They...
67 cj5 f134 mostly original I think. Wiring diagrams in manuals all refer to generator but not sure if po replaced. Tests to tell? Thx
Last week my 67 cj5 with f134 started and ran fine. A few times in the last couple of weeks the starter would disengage while cranking so I'd...
67 CJ5, F134 all original. I just removed a wiring harness the PO had installed when he towed the jeep. Neither b4 I removed it nor now do I...
Driving around today....everything was fine on hard surface roads. heard a few "new" clinks in the transmission and then suddenly I had no power...
i've looked thru my manuals and online to see if there is a gasket or seal where the oil filler tube connects to the engine. I can't find any...
Separate names with a comma.