Well after much frustration, turned out my flamethrower coil was bad (thought they were supposed to be good for a long time?). I replaced it and...
Thanks. What about the number of turns on the mix screws? Can they be so different? I know 2-2.5 turns out is pretty common for 2G's. What are...
I just finished installing a rebuilt mc2150 onto my 225 with the mr. Gasket adapter #1937. It all came together fine but the jeep won't start. The...
This sounds like a great tip ^. Thanks.
Thanks for the ideas folks. One thing to note, I installed a pertronix kit in it last year. Not sure if that nullifies the cam lube idea?
Wow, ask and you shall receive..thanks!
How hard is it to put a 2100 on a stock intake? That may be a dumb question but I know nothing about the differences, if any, in 2bbl mounts.
If the issue is carb related, would replacing the 2g with a MC2100 be smart?
Any other symptoms or behavior typical of being 180* off? I guess going through and re-clocking would t hurt if it's not wrong?
I agree that the dirty fuel is a big issue. When the carb was off last, I could see and feel the sticky, tacky, varnished surface of the inside of...
Forgot to add that I've also briefly researched a 2g replacement. Most folks say keep it, others say the best replacement is a motor craft 2100 or...
I just asked a question regarding my poor running 67 too...I've rebuilt my 2g a few times this week! One thing I did just find was that I had one...
I am finally getting the heep up and running after lifting, adding sag steering, power brakes from an 89 xj, cj7 rear tank addition, and topping...
Thanks. You know, I actually saw that listing as I was searching this subject out. Pricey is right! I do have all the parts minus the brackets...
Can this be done? The mount I have for the pump came from a '79 caddy (needed some mods) and would place the pump pulley in line with the second...
Thanks Nick. Any reasons to go one route vs another with regard to building the right setup or hunting the junkyard for the correct length?
I'm looking for either a good donor vehicle to find a shaft of the right length, or would like to know if a post '72 cj5 shaft can telescope down...
Sorry if this is entirely out of date but do you still make and sell sag swap spud shafts?
Thanks again guys. I guess I should get the thing all bolted back together and driving before I make any decisions. I am currently putting power...
You know, I hadn't even thought of the spare wheel issue. This was a pretty ignorant question I guess...I didn't really think things all the way...
Separate names with a comma.