I'm trying to narrow down some steering shimmy issues and figure its a good idea to replace some old parts. Problem is that I'm not sure what I...
Hey all. Long time since posting and now getting back into my CJ5 and commando. Reworking the brakes with new MC and proportioning valve and due...
Hey all. Finally sick of my crappy electric motors, I want to go back to the stock vacuum setup but since the vacuum setup wasn't on the Jeep...
Have this issue and its driving me nuts. 65 CJ5 4.3V6-T90-D18 Stock F&R axles AA chain clutch linkage Warn OD. When its cold, everything is...
Is there supposed to be any sort of gasket on top of the D20 shifter? Both of my Jeepsters have none and the shift rails have no seals either but...
Trying to put a 225 into a 70 commando frame that I've cleaned up but apparently they must have used different engine mounts for the 225s setup...
My son and I decided to get started on a project together that hopefully we'll finish up and have something for when he can drive (4 yrs away)....
I'm looking at lifting one of the Commanados. I'll be putting on different spring hangers and want to keep spring under and I'd like to be able to...
I have a 71 frame that I'm getting ready to sandblast and I went to take off the drivers side motor mount bracket because I saw it was being held...
Seeing if anyone can point me in the right direction before I dig into this. The halfcab isn't on the road yet but when I go to move it, it'll...
Anyone know how possible it is to bolt a T-18 to the 225?
Got some high speed shimmy after rebuilding Blue and today I rebuilt both side kingpin bearings so that is nice and tight. Took it out and its the...
I picked up my $1 Ebay score. 66 Commando all torn apart. Had a little fun unloading the trailer. I figured I'd set the frame onto my 71 rolling...
Tearing into the 71 I took off the drain tube for the heater intake. It went into the pass side kick panel into a large mass of foam and then...
Pulling the saginaw steering out of the 71 to put into Fern and I see that the exhaust will need to be routed differently. Did those 225s use a...
So I have 2 67 Jeepsters here. identical setups. VIN tags show only a difference of one having the smog engine. Both V6, 3spd, halfcabs..... But,...
I tried to get the factory 4.3 harness in my CJ5 wired up as correct as I thought but the engine is doing a bunch of funky things. Not a lot of...
How does the horn button come off. I didn't want to pry it or force it without knowing. The column has a nasty squeal when turning.
Got this Dauntless fired up and running after the PO hadn't started it in a year. Starts up and dies. Tough to keep going. Doesn't like the choke...
So I decide to pull the carb off for a rebuild and the two front mounting bolts snap off. :mad: After cleaning all the rusted gunk and gasket...
Separate names with a comma.