Anyone know? At first I thought it was an x-fer case clutch bellcrank mount but now I'm not so sure. It's got a hole for a cotter pin (top right).
Dang! A few months ago I bought a 4-core radiator for the V6 and just now I realized it's too dang thick. Fan hits it. Drat!! Need a radiator...
Just installed MSD 5 for the '5. :) I like it! One problem though....it seems to confuzzle the dwell meter. Is this a likely side affect?...
Trying to strengthen the fender-to-body section on my ECJ5 fiberglass fenders. I've never dealt w/ fiberglass repair before, so I need advice....
Fiberglass foux-paux....previous owner holed-out a fuel inlet hole in a VERY inopportune place (see black arrow in pic). I'm using a '71 gas...
Right now I've got: Starter solenoid --> "ST" on key switch +coil --> ballast--> "IGN" on key switch Turned the key, no spark. Hooked up...
I'm trying to install the parking brake for a '71, and need to find out where to anchor the cable housing. On the skid plate? tranny x-member?...
Just picked up a t14 mount from 4WD Hadware today, but none of the 3 tranny bolt holes match up w/ it. Not even close! Here's a pic; I inverted...
What's the deal with the shape of those bolt heads? :mad: I boogered up/rounded off the bolt heads trying to remove them. Any prob w/ using...
[IMG] 1. My V6 fuel pump doesn't have a return line, so I've since plugged this 1/4" fuel return line. Anyone else do that? Other than...
[IMG] I've been stuck for a month at this point ^. I want to be able to run the engine for a bit and take the tranny through all the gears to...
[img] Can you guys see the above pic?? On my 4WD rear gas tank ('70-'75 15-gallon), the seam in the middle is the problem. :mad: During the...
With the V6 recently installed on the frame, I'm wanting to run the engine for a while before slapping the body/fender/grille on to check for...
In the process of dismantling a 225 on the engine stand, one motor mount bolt twisted its head off. :mad: Removed the MM, and about 1/2" of the...
Last thing I need to do in this carb rebuild is to adjust the float. Instructions say to "measure distance from gasket to lip on free end of...
Recently I was hammering away at the choke tube that goes through the pass. side exhaust manifold (V6), and I think I damaged its bond with the...
I'm afraid it's involving 1st &/or 3rd, but not sure. It's of a T-86 (V6). There's a gear (cluster gear?) sorta hidden there in the bottom that...
Having issues on the '71-ish w/ :v6: buildup... Problem: Painted up & gave new seals, gaskets to a T-90, W/ single stick D18. Come to find...
When I removed the tower on the T-90, I made sure it was in neutral. Put it back on, and all gears are now "reverse". :oops: I really, REALLY...
How do you guys remedy a foggy speedometer? The one in the tux gets foggy on the inside after driving 15-20 min, even on a nice day. I've got it...
Separate names with a comma.