I went through a few years of not really understanding how important fuel pressure is. I finally have it rock steady 4 psi and doing some long...
To start off, I inherited a very modified jeep and it's been an ongoing project and thanks for the help getting it to a point where I can hit the...
After installing a new fuel pump and blocking return, I got wrapped around the axle. Pressure shot up to 15 psi so I installed a dial pressure...
My fuel pump started leaking in the 225 V6. Same old story, aftermarket tank, no provision for return line. On the new pump, I simply blocked the...
I've been battling an overheating problem for a while. The folks here recommended relocating my trans cooler from in front of the radiator (I have...
I've read a lot of posts about this and I can't find a solution to my problem so seeking help. I posted a picture of my setup. That's an Autozone...
I had my rolling experiment (Jeep) running excellent then it started having a dead spot off idle. I've read it's wise to ditch the Carter and go...
I decided to bite the bullet and put a stock cam and lifters in. Surprisingly it ran good in the condition you see in the pictures. I bet it's...
I'm getting ready to replace my worn lifters in my '67 225. Is this a good kit to use? Seems like a great deal. Buick 225 V6 1964-1971 Cam Kit...
I got a great deal on this '67 a few months ago and finally got it out to do a full test. No fun riding alone so my son and his friends joined me...
I'm getting closer to a safer driving vehicle and in the process of looking for play in the steering I noticed the outer spring eyelet shifts back...
I finally got out to test climb some hills in my 67' CJ5 and notices some stalling. I found this great video and realized some of these mods were...
I noticed a few cupped lifters when I pulled my intake. I decided to hold off changing the cam and lifters for now because it seems to start and...
I noticed the power steering pump locks up when I get to either end of the steering range. The pump completely freezes. I have a Saginaw...
I have a hydromatic 350 connected to a Dana Spicer 18 transfer case. What I've read is the transfer case in neutral could turn the output shaft of...
My tie rods ends are shot so I'm replacing them. I would just replace the ends but the PO tie rod seems short at about 35 inches and to compensate...
In my ongoing effort to get this project running and back to life, Aquired A 67 Cj5- Highly Modified Help Needed 225 V6 Dauntless Video -...
Thought I would consult the experts. Part of the ongoing effort in getting a new project running. Here is the background... Aquired A 67 Cj5-...
Hello from the California Desert. I recently aquired this vehicle. It sat in a yard for over ten years so I've gone through all the usual stuff...
I know it's not from a Jeep but still very cool. This engine is out of a mid 50 pickup. Has original serial number and rebuild tag. Looks like...
Separate names with a comma.