I got my T14 and bearing retainer from Herm over 10 years ago. Still working great. Not sure if the bearing retainers are the same, but Herm...
Image by Rob C posted Nov 24, 2015 at 10:11 PM The "Nomad" with her new paint. 66 CJ5, 225.
Oh, got you. Guess I should have read your original post closer. Good luck. I'll be following this as I really don't like the fenderwell headers.
I have a set of Hedman headers on my 66 with Herm's steering kit and it clears fine. It's a little close but I was able to make it work. I'm out...
Thanks. Ive had no luck finding a boot like the one pictured and the part numbers above for the single stick. When I got the jeep it had a...
My 66 has the single shifter for the transfer case. It is stock.
I did Herm's conversion while I had the body off the frame. Easy to install but would recommend that you get his banjo fitting kit too. Makes...
Try Double D Fab. He makes all years and can even customize one if needed. I bought one from him and it is very well made and fit perfectly....
Very nice! I'm getting close to taking the plunge with the Herm kit. What kind of work did you have to do to the stock steering shaft. Did you...
IIRC, you do not need to cut the axle shafts when using the Warn hubs. I have a 66 with a D27 and I did not have to do any mods. I'm pretty sure...
The set from Quadratec comes with the fittings that you need. If you order lines individually from a place like classic tube then you'll have to...
I may be wrong, but I think the older ones had safety issues and were not DOT approved. Supposedly the new ones are. But, I'm actually thinking...
Paul, I just got finished replacing my front and rear with Goodridge braided stainless from Quadratec. The rear fit fine, but the ones that they...
A few years ago I swapped my T86 for a T14. I had to have my rear drive shaft shortened a bit. I figured that since it was such a slight increase...
On my V6, I had to take out the driver's side exhaust manifold to get the box out. May be a way to do it easier, but I just couldn't get it to...
AIRSHIPDOC, Sent you a PM. Rob
Don't mind at all, but I am heading out of town early tomorrow morning for the weekend. I'll be back Tuesday and will get you one then. Sorry for...
Mine are zinc coated, I think. They are a flat silver color which I'm pretty sure is stock since they still have the factory 12V stencils on them.
Rocky, I really don't think so. If you look down into the top of the tube, you will see the bearing. The outer bearing race was very hard to get...
I just replaced mine last weekend. I doubt that you would be able to get any lube into the bearings without at least taking the steering wheel...
Separate names with a comma.