The PTO looks like one I have for sale [IMG] [IMG]
You are going to fab a new cross member to go across the frame rails right? ;) This is how I did my last Jeep cross member [IMG] [IMG]
Gr8 progress. Maybe I need to be unemployed..... Oh wait unemployment = no dinero $$$- uh forget it R)
Oh the joy of it all R)
Definitely looking good. Lots of work isn't it. ;) Organize your garage like mine. I am trying my best to keep it so the wife can park her car...
It's chevy engine Orange :D I figure I changed it from being a Ford into a Chevy performer R)
Really? It only takes up half my monitor. They are hosted on photobucket, and they usually downsize them from original. Maybe monitor resolution...
I started a new thread HERE detailing what all I did with my bead roller. It's all done now.
I hope it's ok to post this here. I know it's not necessarily a Jeep fabrication thread, but it is a tool that can be used for Jeep fabrication....
I hope so, since I am a one man show here ;) R) Actually it's a timer I had laying around. I will be using it as a relay, since I don't have a...
I got the motor in the mail today, and needless to say, I couldn't wait.... so off to Graingers I went to get a coupling for it. Got it all...
That is a cool site. I am debating on painting mine the original spruce tip green. Haven't really decided yet. Might have to run a poll and let...
I think I'll buy 2 more of those roller stands, since HF has a coupon book for them for $10 ea. Trouble is I turned in the coupon when I bought...
Sorry it's taking so long to get pics up. I just used some round tube I had laying around to beef it up. It took care of 95% of the flex. Please...
I plan to use a foot switch, and then I will use a toggle switch for reversing it. I'll try to get some pics up today, of how I reinforced it :smash:
I just won the motor yesterday, so I have to wait for it to show up. HERE IT IS
I was wondering the same thing also. I already beefed up my Harbor Fart roller. Works good now...no flex. I also got an electric gearmotor off of...
Cool thanks. I just picked up this at HF. Got it for 110 out the door. http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=34104
It's my wifes clothes not mine:twisted: Jim, I already gave up the workshop (barn) to her for the horses, I'll be darn if I am going to...
Is it best to start the bead from the center of the panel and work towards the outside edge, or does it really matter?
Separate names with a comma.