Today was 81* out. Ran down freeway Between 60-70 mph temp was at 190* [ATTACH] pulled off the freeway and stopped at bottom of off ramp and it...
John, I have always wondered how much that shroud is doing with the bottom open. I went to the parts store today and picked up items needed to...
Thank you.
I was reading this thread and bought #J5357390. It will need the holes slotted about 1/8”. http://www.earlycj5.com/xf_cj5/index.php?threads/156120/
Heck, that’s just a case of beer from being done, it’s already a roller.
I used ARB bolt kit....
I replaced mine with studs.
Since I already have the 5-blade, I’m hoping that the 7- blade will make a difference. I’m also going to try running the shroud again.
I was running a stock water pump for the last 4 years and switched over to the Flow Kool last year. It did help with the temps at lower speeds,...
I’m pulling intake off to reseal so I’ll throw in a new thermostat. I’ll throw it in boiling water to see if it’s working also.
The temps were steady 180*-190* before the build. It is bored .60 over. Complete rebuild. http://www.earlycj5.com/xf_cj5/index.php?threads/118867/...
This is the same shroud I have. I was going to try running it again with the 7-blade fan.
I have been fighting a heating issue with my V6 JEEP since I rebuilt the engine. It runs @ 180*-185* running down the road in 100* weather. Once I...
How’s it running?…could the timing chain of jumped a tooth.
Sorry, what I was trying to ask was if the rear wheel cylinders are the same (bore) size as the originals. The different sizes will change the...
Did you change out the wheel cylinders? If you did were they the same/right ones? You might try re-bleeding system again.
So this is where you been hiding… how’s the new to you CJ6 coming along.
Thanks Tim, I’ve been running them for the last 5-6 years… and your right they are comfy.
I finished the seat belt harness and got that all done. [ATTACH] [ATTACH] [ATTACH] [ATTACH] I got all the parts for the frame tie in, I’ll...
Separate names with a comma.