I have a 1969 CJ5 with a 225. I have a DUI distributor, new plugs gapped to .55, rebuilt carb, new plastic tank (under the seat), new sending...
Does anyone have a pic of the Dauntless decal that goes on the oil bath air cleaner for a 1969 CJ5. Not sure where it is suposed to be placed....
I am getting ready to install a new plastic gas tank (under the driver's seat) and sending unit on my 1969 cj5 V6. Are there any tricks on...
Thinking about putting a overdrive in my 1969 cj5 V6 T14/D18 single stick. I have read the post about the installs. Can someone post a pic of...
Thinking about putting a rear seat in my 1969 cj5. What do most people think, is there enough room to sit? Should I leave it empty? I would...
I just removed my water pump and there were 4 long bolts, 3 of these are approximately 4.25 inches long, and one is 5 inches longs. Not sure where...
Not sure if someone can help. I have a 1969 CJ5 and purchased a DUI distributor, but it won't clear the intake and needs to go down two more...
Looking to see if anyone has any ideas for a good full sized jeep/car cover for a 1969 cj5. It has a spare tire carrier with a 31"
Does anyone know what size bellcrank repair kit I need for a 1969 CJ5 with a V6 225. Mike
Anyone have a source for the gaskets that go from the headlight bucket to the grill. Actually I need all the gaskets for all the lights to go on...
Does any one know if a body panel from a 1976-86 CJ5 SIDE PANEL will fit a 1969 CJ5. I know these has probably been asked before. Are there any...
Was a dash grab handle available on a 1969 CJ5? If so does anyone have any measurements for the location. Thanks in advance, Mike
Does anyone know what the space between the two fronts seat is supposed to be for a 1969 CJ5. My jeep is at the body shop right know and I was...
Anyone used an AIRAID air filter? I called AIRAID today and they say its a exact replacement just have to drop it in and you can still use the...
Wheelhouse notch or different seats? I have a 1969 CJ5 and just dumped a lot of money in it. The problem is now that I have found out that it is...
I picked up a roll bar on the way down to see my folks. Just wondering if its going to fit now. Its 33 inches tall, the plates that bolt to the...
Does anyone have a source for a old style roll bar pad and cover? Or any sugestions. I can't find anything on the web. Thanks
Does anyone know if there are spacer that goes between the brake line to the wheel cylinder. I have installed new stainless classic tube steel...
I have a 1969 CJ5 V6 with a 1 inch Rancho supension left. I have been looking to pick up some tires and rims. I don't want to screw fender...
I have just torn apart the front knuckles on my 1969 CJ5 and I have installed new seals. My question is 140W gear oil ok to use. I have picked...
Separate names with a comma.