Tank is dropped, fenders off, bolts chopped, and tool box removed, now I'm ready to put her up on 4x4 blocks. Before busting the welder out and...
I did straighten her up. The seep is just enough to be annoying.
Thanks for the heads up! I'll give Auto zone a try.
So after swapping out winches and getting rid of one leak, I couldn't help but eliminate a couple of others that'd been bothering me. Knocked...
Success! I pulled the upper I'd been fighting and opened the other rms box. Looking at the two side by side, I realized the problem. The one...
Alright, the lip of the seal is facing the front, I'm doing the old in-out and have made some headway. Now I'm hung up 3/4 of the way in.
Thanks, I'll try the ol' in-out tomorrow.
Thanks, I'll try the back and forth tomorrow.
I've run into a problem getting the top of the rms in. The old one came out easy, the new one isn't wanting to go in very far(about halfway.)...
I've got a similar problem getting the top of the rms in. The old one came out easy, the new one not so much. I've followed all advice, she's...
i snapped a couple of shots of my Ramsey MX200R last night while in the garage. Do you have an email address I can send these shots to? I've...
So I ended up with one bolt in each spring hanger. The easy part was drilling out one of the 3/8" holes in the hangers, then it was a contortion...
Thanks, I'm glad there's enough flex in those springs to move 'em around, I'm looking for the easiest way to get this done. It's just something...
It's been a number of years since I farmed out the install of Holbrook springs on my '73, they've been awsome both on and offroad. The one thing...
Thanks for the heads up. The speedo cable is spinning and I've installed it with as wide of loops as possible. The replacement head is a Crown,...
Thanks, I'll give Debella's a call.
The speedo I've got was a replacement after blowing the motor 15 years ago. Its' only clocked 14,612 miles and has no stop pin on it. Any hope,...
Yes, nothing until ~20 mph, then away she goes...
One thing I've needed to do since swapping transmissions is install a longer cable for the T18. Sourced one, installed it, odometer works...
Holbrook gives you new spring hangers to burn on with their long leafs. When installed I also had burned on rectangular plates to reinforce that...
Separate names with a comma.