[ATTACH] Left and right side jeep embossed pieces cut from scrap body. $50.00obo Fuel filler piece. $20.00obo Rear bow sockets.$15.00obo All...
Has anybody put a hydraulic operated clutch on a T90 mated to a F134? Kind of in the planning stages of trying it if anyone has picture or a list...
Looking for a t98 to mate to a f134 and dana18 transfer case..
https://www.facebook.com/marketplace/item/668049198295684/ This is the real deal cherry one owner I have seen this one and know the owner.
Looking to buy a t98 to mate to my f134.
1) set of early front fenders inner wells cut for headers free 2) early hood has a dent and inner support brace cut to fit radiator free...
I’m trying to set the timing on a F134 there is no timing marks to be found .if I use my finger to feel for it to stop pushing air and look at the...
I'm going to flip my tie rod using TMR tapered bushings standard jeep taper . What size do I drill out the holes in the knuckles to I've heard...
I need the distance from the end of the frame horn to the front edge of the first cross member grill support.
Got a Benchmark abrasive grinding hood a while back best 40 dollar tool I've bought keeps the bad things out of my eyes and face would recommend...
I’m doing the Brennan metcalf disk brake conversion . The directions say to drill out the rotor wheel stud holes to 39/64 that is a odd ball drill...
My new cluster gear doesn't have the relief cut in it to locate the thrust washer dose it need it or do I need to get them machined in. Old gear...
I can’t get any end play I’ve got 3/64” of shims stacked and still can’t get any movement of the rear output should I keep stacking or look for...
I’m installing a tapered bearing kit in my transfer case do I need to use the thrust washers? I tried but they won’t fit between the gear and the...
The ring of bolts that hold the two halves of the carrier together what should they b torqued to?
Rebuilding the Dana 18 and found a bad spot on the sliding clutch gear. The corners of the gear are slightly rounded off and a chip out of one...
Stocking up on parts and the front axle is next on the rebuild list. What size reamers do I need for the knuckles to flip the tie rods on a...
So I bought this 1961 cj 5 about 6 months ago the only thing it had that was any good was a clean title and current tags. The body is in fair...
can you bore a small hole 18 case out to 4" to bolt it to a t14 transmisssion
is this a good choice if not what would you recommend http://www.summitracing.com/parts/CLO-C-3018K/ thanks
Separate names with a comma.