No, you need it on the bench to get it apart. There is a snap ring holding the output gear on the shaft you have to get off before the shaft...
I have had good results using the tool that Eastwood sells for making double flares on steel or NICU tubing. Beware trying to flare stainless...
I once cut the dash welds on a customer's Jeep, then used bolts to re-fasten the dash. We had to remove the dash to put in an overhead swung pedal...
I went to the hardware store and bought a masonry chisel. It had a blade about 4 inches wide, and I cut a 'U' shaped notch in the center of it big...
Focker, (and anybody else interested in this) I have opened up one of these Crown MC and looked at the bore size. It has a straight 1" bore for...
Hmm, valve train noise. When I first looked at the Yellow Barn Find in the owner's driveway, we got it to fire up briefly and it had a couple of...
If I remember correctly, the Prestolite starter that was originally on my V6 used that bracket on the front of the starter motor. When the...
Plan on an oil pan gasket set as well. The way the timing cover sets are sold includes a short little piece of cork gasket to replace the front...
Have you opened up the new Crown unit to see if it has a stepped bore like the original Wagner Lockheed? Don
Hey Focker, Now that you are into this thing this far this is the right time to check the king pin bearings and races that hold the knuckle on to...
Just the aluminum bell housing, threaded holes for the transmission adapter. Don
OK guys, I got a question for the gurus. I'm working on a swap job for a customer, putting in a 2006 Chevy 4.3 V6 mated to an SM465, going into a...
Don
A 2 1/2 lift will clear 33 X 10.50 tires on my '70 with slight rubbing of the inner sidewall on the front leaf springs only on max turning...
OK, so what was the application for that certain GM E brake cable? Don
Jeff, The pressure pot I was using was putting almost a gallon through in under a minute. I had all 4 wheel bleeders open with plastic bottles and...
It's hard to tell from your picture of the steering box, but is the mounting plate spanning from the top to bottom flange of the frame rail? It...
Jeff, I just did some work on a '65 doing a conversion that sounds similar to yours, with similar issues. Front disc conversion using Chevy 1/2...
The older Tcase with the 3/4" intermediate shaft did use a double set of caged needle bearings. You will find these on an original 2A Tcase. Don
John, That video was something. The tool was turning to fast to tell what it was, maybe a boring bar with a carbide cutter? And it looked like it...
Separate names with a comma.