Monza, never used it but know two people running them with 4.3s. Just happen to see this today at lunch....
According to this link http://www.generalspringkc.com/index.php?p=catalog&parent=141&pg=1 a YJ Spring is 22 11/16. Flatfender spring,...
I don't think it can be clocked far enough to cause an oiling problem, just because of the adapter casting limits. I'm still struggling with to...
If I'm thinking right, the shifters should just need to be bent to go straight up through the floor. The Xfer should revolve around the round top...
Maybe with the stock small V-6 u-joint, which I have, but I'm trying to run the large ones. It is also running to a FJ40 front axle, which I think...
Anyone done it? and is it worth it? After looking at the adapter, it looks like moving the 4 bolts holding the adpater and trans together would...
Re: leaf srping question If you have the fab skills to put a coil spring suspension in, put a custom pack in the back. Find a used (free is...
As above, POR15 breaks down in UV. I believe they have a chassis paint specifically for the frame.
This was a couple of years ago but: After researching, found with time/money/bla bla bla, that the Pirate board (PBB) has some venders that cut...
Should tow just fine. The lack of a column will be less turning parts. And yes, the steering must be unlocked to flat tow.
Scouts are oddball and need the arm changed. Believe Ford and the Toyota IFS boxes are very similar. All the above will require a large chunk of...
If you're going to stay 33 or smaller, the 4in lift would be the best thing to do. Whatever you do, new springs and some type of traction bar is...
If it's going to see hi-way miles, a higher gear (4.56) would be nice but with the 3sp and D20 that kind of limits how hi you would want to go....
Always try the HHO conversion, some say they get a nice boost in mpg. Never tried it so can't say yes or no if it works. There was someone on...
Any stock D44 you want to use will have to have the springs outboarded. Also, you're looking at 42" tires, that is a big tire and would probably...
I vote for a full cage, and see two options that may not give the same support but will be better than nothing. 1.) When the front leg come...
This won't be a problem. I'll limit some radical articulation but make it more stable over all.
Put a spacer between the frame and spring for the distance you want. Then leave the final mounting hole until all the weight is on it. This will...
Re: Lets talk frames... I hate it when they do that, Jay did a nice job on that too.
Speedwaymotors.com has lots of universal parts, hotrod parts work good. I used AN- fittings, adapters, and braided steel flex line to replace the...
Separate names with a comma.