How about a Chevy 4.3 V6? fits nice and lots of power.
Looks good, I like it. Jeff
Sure, I love to display my work. I have to finish the floor up them I can get started on the supprots, stay tuned. Jeff
Not really, but I am taking donations for my project, you could have your name carefully place inside the rear bumper of my Jeep when it's...
Steel price's suck! I know they have been going up but I just picked up a 24 ft section of 16 ga. 1 X 2 rectangular tubing to replaced the hat...
You can end up with leaks after switching to synthetic oil's if you have old seals in your engine. They will form a false seal of varnish that the...
I could use the tools if their still around Jeff
Can anyone tell me the difference between a T-14 and a T-86 Transmission? Gear ratio's? Do any parts interchange? Or can you refer to a site that...
I set the two frames side by side and measured the heck out of them, three inches on the rear, you can cut off two easy, and the front is no...
If you live in rust country and your frame is in good condition you should have no problem selling it or trading it for a CJ-5 Frame. Jeff
The 2A frame is 3 inches shorter in the rear and I think 4 inches longer in the front. Fronts not a problem but the rear may. I'm doing the same...
Where about's in the UP are you, I'm in the lower but get up to St. Ignace a lot, have friends there. You have a flat Fendered frame, 2A, 3A, or...
If you decide not to fix it I could use the front bearing retainer if you want to sell it. Jeff
Let me know, the cut out is there to clear the lower gear so i'm not sure what going on. Jeff
The main drive gear has a half moon notch, after you remove the retainer rotate the main gear to that notch and it will pull out the front. Watch...
You will also need to swap the bearing retainer along with the main drive gear. Jeff
On my last build, another 47 CJ-2A, I mounted the battery behind the passenger seat and still had a rear seat. Just no leg room on that side. I...
Check the side's of the body where the opens for the cross shaft for the throttle plates are, could be worn. Check for cracks at the base of the...
Ya, you could get a hand crank for the engine, never used one i'm sure is not dangerous or Ralph Nator would have had somthing to say about it.
Separate names with a comma.