I am looking for a filler neck, the metal piece that is held on to the body with two screws. This is the piece that the filler hose connects too...
Here is a link from Warlock when I was having issues with my 231: http://www.novak-adapt.com/knowledge/clutches_etc.htm Also in my post New Clutch...
Well, pulled the clutch boot and it was alittle hard to see, but I found the problem. My clutch fork jumped off of the T/O bearing and was in...
Thank you all for the advice, I just got back from camping. I am hoping to get back after it in the next couple of days. Thank You again,
I don't know, atleast I thought I did. Thank You, atleast I have a starting point...will investigate.
I have searched the forum, but could find similar issues with a new clutch so here are my issue. I finally found the time to finish putting my...
I have been searching and searching for a thermostat bypass hose for a 231 buick, would think a hose off a 225 would work as well. Went down to...
Thank You, I'll look at that part number, also thought a 7447 might work.
That is what I have been attempting to do, but the hose seems to pinch. So that is why I want to find a molded one.
I am looking for either a NAPA part number, any other part number, or source for a Water Pump By Pass Hose for either a 225 or 231. I have found...
My 71's brake block & front pressure switch is basically in the same locaction as yours. Just as dnb5853 stated, a tube bender & I would add a...
Going with the 4.3, don't you need to move the motor mounts, off center the motor, or channel the fire wall? Seemed to be several mod's that need...
While l rebuilding my steering box I remove and completely cleaned my drag link. Once cleaned I noticed groves and wear inside (while looking...
A resistor that has the property of increasing in resistance as current flowing through it increases, and decreasing in resistance as current...
Now you have me nervous since half of my drag link is removed. Anyways according to Moses Ludel, Jeep CJ rebuilders manual (46 to 71), pg 402:...
My ticking noise after changing the timing chain & gears, lifter's, checking for exhaust leaks, ended up being a spun rod bearing. Just hope this...
I used .001 to .003 Plastigage (green), and in a nut shell put the pump together clean. On four points of each gear I placed a small piece of...
Is the Distributor seated all the way down on the oil pump shaft? Or is the pin at the bottom of the distributor still there? I know when I...
Auto Zone Fenco New/Master Cyclinder #NM1373 $80.99. Before NAPA changed ther web site I crossed that number to a NAPA number, bench bled and I...
As my search continues I have an additional question. Back in the early to mid 60's they changed out the 4 cyc for the V6 Buick. Did they change...
Separate names with a comma.