Just a quick question. I have a customer that I am working with that wants to put a 4 speed sm465 in. I know it can be done with the 225 and the...
Sorry to chime in late on this one. I got the plastic duct for my 69, went to the FLAPS and got preheater hose that would fit the opening on the...
My linkage locked up once on me, I found that taking both wipers off and using tape to figure out there there going to swipe helped. Might try...
Finally found the new part listed online last night. They used the 18-8-49 in both the dana 18 and dana 20 depending on the engine. The V6 with...
Pics of the broken gear, plus another question..... How does the Mainshaft gear in my Dana 18, manage to be the correct part # from a Dana 20...
No other broken teeth in it. Got about 125 miles on it since getting it back on the road. Had some surface rust on a few of the gears think that...
It's official. 2 broken teeth on the main shaft gear. 26 tooth 10 spline imprinted 18-8-49. Now off to the parts hunt. THanks for the input
We got it up in the air, nailed the noise down the t-case. In the process of draining the full synthetic fluid, pulling the inspection cover to...
:? On the drive to work today, got off the highway and was coasting down the exit ramp, shifted to neutral and released the clutch had a...
Well it looks like I am gonna have to pull it apart and see exactly what is rubbing and where to see if it can be cleaned up to be kept quite or not.
brake drum is straight and backing plate has clearance as well. If I gotta pull em apart and do the shoes to get rid of it then I guess I will...
Alright, I have gone thru just about everything I could on this Jeep, I replaced the parking brake shoes on the rear driveshaft, adjusted as in...
Ryan, Your high beam indicator should be around the 11 o'clock position on your cluster. Nothing special just a hole in it that lights up when...
Thanks, for the input. I'll know more when I get it here and get it installed if you wanna get a look at it Chuck.
Mine was missing when I got the Jeep, I only have the cover and wiper motor itself. Used a little rtv around the top and corners of the cover to...
Said screw it, ordered one of the right angle adapters, printed the directions found in history on how to take apart and clean/rebuild speedo...
Mine has been doing the same thing or going up then hanging there. I haven't lubed the inside of the speedo itself yet, but did find that if the...
Would also advise to stay away from the rubber, I ran new steel lines from the tank to the top of the block and in places that there was going to...
Sounds like tranny/tcase to me too. Agree with the chocking the wheels idea too. where are you located? there people all over the country here...
Not sure if the later model stuff would work, I just got done doing my brakes last month on my 69, I have before and after pics if you want em for...
Separate names with a comma.