I stumbled across this video a while back and tried the technique last year fixing up the CJ body. It works very well if you are careful with the...
Does it still have points? I chased a similar problem with my jeep years ago. It ended up being a bad condenser. I even did the same thing to...
I don't have a lot of room either. I tried to use all the space around the best I could. Custom cabinet above with a little shelf for keeping...
Over the past few years I have been tinkering with an alternator powered welder with mixed success. Recently, it’s gotten to a point that it...
Looking at the calipers that they sell with no motor at Rockauto, it looks like maybe you could take the motor off and spin the shaft manually...
Yes, I have an SM420, but it looks like the shifters are close to the same place as yours. I think I had to notch into the tub floor a little. I...
Mine is not a T98, but might still be helpful. [IMG] [IMG]
Oh yeah, I forgot about that! I have an F134 too, but I swapped the bell housing to use a different transmission.
I did mine with a push cylinder. Made the bracket and a push rod. Bracket attaches to the bell housing bolts. I had the mechanical linkage set...
You could put it in first and TC high and count how many turns of the input shaft to 1 turn of the output shaft.
I don't think it rusted through, I figured it burned through as well. Other than the head bolt possibly being below full torque, I don't have any...
I almost threw in the towel on the Rubicon trip this year at the trail head because of this noise…..but here’s the whole story….. The most...
(y)(y)
Here is the support bearing I used. https://www.summitracing.com/parts/brg-700010/overview/ Most of these support bearings look like rod ends....
I found some photos of your L-head during my research phase. It was nice to see it could be done....not many out there. Yes, going to install a...
All of the steering linkage components are Borgenson. Bought them from Summit because they were a little cheaper. All that stuff is deceivingly...
Supply is 5/16" inverted flare, return is 3/8" inverted flare. Used this fitting for the return...
I think you'll like it. I think the only advantage I noticed that the front mounted box has over this is that the for the front mount, the...
Thanks for the encouragement guys! Yes, there is a small heat exchanger in front of the radiator.
Separate names with a comma.