Glenn, I've sent you a PM. There's plenty of engine clearance, but some things would need adapting like the large air filter, the brake servo...
I had thought about replacing just the J54 fenders with 3B ones , but much prefer low cowl Jeeps if I'm really honest. ;).
That looks good, but my 3B has SOA, so there's already enough clearance on the fenders. I said 3B, but its actually a J54 diesel and apart...
I've been thinking about converting my 3B to low cowl / hood, but thought I'd ask before starting the cowl chop to see if there are any issues I...
I'll give ya a good profit, fly you to england, put you up for a few weeks and take to to meet the queen,, maybe have tea on the lawn with her,...
I hear lots of bad reports about Juan stuff, but I have their fenders, MB grill and a few other parts fitted to my USA built tub, along with a...
Thanks Nickmil.
Guys, any suggestions as to whats a good diff cover to buy that has a higher filler? running a D44 with SOA and looking to get more oil in it due...
THANKS, much appreciated Steve.
Steve, the clips on mine clamp down on the bottom edge of the cap and the rotor is pear shaped, the coil feed (from dizzy to rotor) is not...
Thanks guys, another problem with the dizzy fitted is there are no markings on it, I hunted for markings two years ago and found nothing and now...
Does anyone know if the distributor caps on the MB's are the same size as on the cj2 & 3's. I picked up an MB cap which I was told would fit my...
Mitsubishi did the J54 and 53 I think they were all diesels 2.7 turbo & n/a motors.
Thanks Rich, I did a google search with that name and come up with this > http://www.malotmgf.com/jeeps.htm. Then I did a little further...
Years ago I read about a project for an off-road magazine built by journalist Richard Johnson, the one they built used a repro CJ5 fiberglass...
HELP!! Can anyone tell me if fiberglass body tubs are still made for flatties? if so, how good are they? and where can I buy one from?.
Cant say mine is stock for sure (not much else on it is:)), but it just looks like a piece of thick wire/bar bent into a V shape, about 3'' deep...
Could anyone ID a transfer case for me by these casting code/numbers? > JM61591 which are the only numbers I can find on the casting. THANKS
I did this on my 2A but like the guys say, you need to use the MB headlamps too, which swivel around to shine in the engine bay, what a great...
I kind of regretted not bidding higher after loosing out on the deal, until I read that ^ seems I need to get the canoe out now ;) A good...
Separate names with a comma.