Go for an International Scout saginaw-box. In my opinion the best saginaw alternative for ECJ5. No problems with the steeringshaft, manifold,...
Hi, does anyone know if T-18 from a Ford or Scout is the same as the jeep version? My friend has a T-14 behind his V6 that needs to br replaced...
I know that this looks like a m38a1 frame, my question is if anybody else with very early CJ's have a frame with all m38a1-stuff on it. I guess...
Still think its strange that the frame has all the m38a1 stuff on it, I've never seen a 5 with such a frame....and i feel I've researced alot.:) I...
Thanks for all replys guys! It has signs of a batterytray on the front crossmember, but it has been cut of. You can just barely see it on one of...
Hi, my friend has bought himself a frame that was supposed to be a CJ-5. The title tag that comes along with the frame says it is one of the first...
Ok, thanks!! I think I'll plug them then. I've got a temperarure sending unit on my intake. :)
Hi again guys, have another one I hope someone can help me with. On my new (reman) 231 block there are two treaded holes witch are'nt on my old...
Thanks alot! I dont know what a brush tack sealer is, it came with 2 black rubber gaskets/sealers for the front and rear edges of the valley.
My question is really if I need the composite-gaskets in addition to the valley- pan gasket? Can't remember seeing any gaskets other than the...
Hi again! New problem, new question. :) I'm wondering witch of theese intake gaskets I'm going to use, or schould I use both?? [IMG] I bought...
Here is what I'm talking about. [IMG] The rockers goes into the sides of the pedestals, as you can see the shaft still schould go about 1/5...
I figured this one out, I just tapped them light with a nylon-hammer and they went right in place. :)
Hey, great! Allways help to find here at ECJ-5! :) If you cannot find any intructions maby you can help anyway. Right now there are 3 things I'm...
Ok, now new ones are purchased, or old new ones. I was looking around for parts here in norway because the vulcanos on Iceland made it difficult...
Hello again! New problem, new question. I took out my crank-shaft, and when I put the bearing caps back in they dont seem to fit. They seem too...
Here I have got some pictures of them, I guess they are not so bad if they are suposed to be "loose" on the axle. [IMG] [IMG] [IMG]
Thanks alot for all answers. :) I will take some pics of it one of these days and we'll see. I would think that they dont lift as high and...
Hello again, I have a new problem I hope someone can help with. My rocker arms are the stamped out type and they sit on axles on the tops. The...
Now I've done it the way you said Kaiser, and now it turns like a dream. Dont know about the pump since I have'nt started the engine yet, but i...
Separate names with a comma.