I've always thought the A1 only came with an f-head. This makes me think I'm wrong....
Fairly complete. https://www.facebook.com/marketplace/item/292221283318842/?mibextid=dXMIcH
I'm not sure if the price is out of line but I like it...mucho. https://www.facebook.com/marketplace/item/984484429416524/?mibextid=dXMIcH
...and never tomorrow. https://www.facebook.com/groups/455722995008845/permalink/1317615508819585/?sale_post_id=1317615508819585&mibextid=Nif5oz
Engine runs fairly well standing still and while revving the engine. Under load it starts running rough and is slow to accelerate. Should I focus...
I'm having an Fhead starting problem. I have full voltage to the distributor except when the points are installed. :confused: With the points out...
I'm installing new oil lines on my f134. The fitting on the timing chain is boogered up. It has a hex head on it but it's brass so it's rounding...
My M38A1 has a starting problem. It has not been started since I rewired it. I used a wiring harness specific to M38A1s. According to the...
What is the proper name of the connector in the pics below? Does anyone have a source or P/N? Thanks. [img] [img]
What is this spare bolt hole for? [img]
I snapped of a bolt that is inside the block of my fhead. I'll blame the bolt and not me just because that makes me feel better. I had to remove...
I'm having trouble with my starter foot plunger being out of alignment and being too far from the starter lever. When the plunger is completely...
I have a postal steering column. I've had it out for 4 years or more. I can't remember how the bracket mounts to the firewall. The existing holes...
Here are some comparison specs someone might be interested in. [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I need to rebuild my fuel pump and have some questions. There seems to be a big difference in the price of rebuild kits. Obviously quality...
I'm rewiring my Jeep. Definitely out of my element. When I removed the existing wires I don't remember any leads coming of of the alternator with...
Like all early CJs my M38A1 originally had a generator and regulator. At an unknown rate mine was switched out for an alternator with an internal...
I've seen previous posts about the original hex head screws with the indented heads asking what people are using. My experience is with a '53...
I'm looking for some pictures of T98 tranny covers and how they line up with the lower floor panel. Also, how did you notch the floor panel for...
What is the correct way to route a wiring harness to the rear? On the bottom of the inside of the left frame rail? Does anyone have a source for...
Separate names with a comma.