Does anyone have pics of these colors? I have seen riverside orange but have not seen 72,73 renegade orange. From the PPG book they did not make...
I have searched and found you guys using ospho to kill the rust. I have por15 and the advise to use a metal prep, ospho, to clean the metal. I...
I'm looking at paint for my 5 and the paint shop says I need to apply epoxy primer then high build primer followed by a sealer primer. Do I need...
What do you guys run? I have highback bestops and was thinking the low standard seats would look better. I have shoulder seatbelts. I also want...
I have been searching and can't find how to check the caster! I have a angle finder but I need to know where on the axle to get the closest...
I have been having problems with my prestolite distributor on my 360 so after many searches I found the Team rush upgrade. It is a larger cap and...
I have been sucked into all the build threads I can find and I have a feeling that I'm going to go out in the garage and take my body off and...
I'm doing the brakes and ujoints on my 73 and there is a shim behind the spindle. I thought it was flat and did not mark it and as I was looking...
Finally got some pics up. Had to build a tire carrier/bumper for my cj. Paid less then $100 bucks in steel and misc. I needed something to hold...
So now it is time to fix the brakes. The pass side is grabing and pulling to the ditch when the brakes are applied. So do I rebuild the stock...
The PO did the swap so I don't know if I need the plate between the bellhousing and the motor. I pulled the motor and had it rebuilt and I did...
Okay, I have a new rebuilt carb on my 80ish 360. It seems to rum well once warm but I have yet to get the chock working properly. I searched and...
Are they stock on a 73. Or were they on the Renegade models? Thanks for any help!
How hard is it to do? Mine is leaking oil out the front and rear outputs. Also by the shifters. It seems to work fine, but I have only driven...
I have seen them both ways. I personally dont like the little plastic ones. I have them, should I put them back on?
I have a 73 with a 65ish tub on it. The PO took the whole heating sysytem out and I need heat up here in Minnesota! Will the 73 heater ***. fit...
I did a search and wanted to run this by you guys. Are all the saginaw pumps for gm and jeeps the same bolt pattern? I read that the ratios are...
I just took off my fenderwell headers and put on a pair of stock manifolds, to solve the leaking problem, and now it looks real tight on the...
I have been working on my cj for a while and now its time for some mufflers! I have a 360 with fenderwell headers that leak on one side. Also...
This is my first post. I hope you guys can help. I have a 73 cj5 with a 360. I bought Rustys offroad 3 inch lift and the front springs are way...
Separate names with a comma.