Also Thanks for that.....That's also why I'm asking.....had I asked before messing with the fork and cable.....I might not have needed to remove...
Thanks for the great and less expensive idea. I'm doing this in a dirt driveway, so the wheels on whatever jack might be a problem....I'm also...
Thanks for the advice....I'll do the floor jack thing. I need one more then a tranny jack and they are so much less money. I also don't need to...
Thanks for the parts places.....Krage's seems to have lots of photos.....since I'm still learning that seems good. I will be attempting the trans...
Got it out, no problem...and no springs etc.....Great.and Thanks...... Any one have any idea were is the best place to get a clutch fork for 1971...
I have worked on this Jeep since Feb....and things were moving forward ......the engine working real good etc. Then.....after taking it for the...
OK....Well I sand blasted the entire underside of the Jeep.....sure wish I could take the body off, but .....I just don't have the equipment yet....
I have a Cj5 stock 1971 with Dana 27a Front end, and I think Dana 44 rear. It came with 265x 7515 tires....I don't know much yet. Are these...
Manual is my next tool..... I found the vapor lock problem and fixed it. My fuel line was to close to the engine. Also, my heater hoses feel...
Wheel bearings , king pin bearings and more I don't want to take this all apart like you said, until I know at least what to look for and know...
Thanks: I had it up for two days, and got rid of all the old grease. I didn't take it apart yet. On the drivers side, the 12 and 6 movement is...
No problem with that,or anything for that matter that would be helpful. I know I seem like an info hog, but eventually I'll be on the other side...
Dana 27A King Pin and wheel bearing That sounds great. So I have the entire front axle about clean now. So do I just start by removing...
OK I went to NAPA and they can get Kingpins for about $100 bucks. I also wonder if a DANA 30 from a 1984 CJ7 with disk breaks axle and springs...
[IMG] [IMG] Ok, to get to the wheel bearings and King pin and cup, do I remove all the stuff above. and will there be small parts and...
Thanks for the drawing, I'm still learning....big time. I will pull off the wheel and take some photos. I can not seem to find as much info on...
Well, I got my carb back and put the engine back together, after cleaning 40 yrs of grease and painting it. It runs good now and looks better. The...
www.corbeau.com I don't know if these will fit, but would like to know. Also, Seats from Saturns might work.
Well, I'm still waiting for my carb......I suppose it's a tough job..... The guy did call last week, and said that there were small cracks...
Thanks, will do...
Separate names with a comma.