how well does it drain the block? my radiator sprung a leak back in the summer, it was just a dribble. and i never got around to fixing it. I...
thinking that the saginaw conversion can be done on the cheep side, what year jeep has the correct tierod end with the hole for the draglink? also...
dont get me wrong fellows, i love my :hurrican: but thinking ahead and am leaning tword a 4.3 chevy:) there are many reasons for the 4.3 as a good...
been thinking about this for some time, and have done a little reaserch here and on the net. just how much improvment you think it would give a...
i searched, i read, and i am stumped. my carb has set for a few years, when i put it on the jeep a couple days ago it leaked a little fuel out of...
well after being on the phone for a hour with 4 different parts houses i have the part # for the correct freeze plugs. dorman 550-017 is the...
ok so i have everything mocked up on my d27. and i have ran into a issuemehh the caliper is dead agaisnt the knuckle where the 2 piece seal...
didnt put this over in tech because i didnt think it was really technical, if you feel it is please by all means put it there:) ive been reading...
man am i confused, does the m38a1 use the same springs as a cj5 just heavier? what are the differences if any? its time to replace the rear...
as far as i know there was only one exaust system for the 134 cj, ordered it a few days ago, and went to put it on, question is how does the rear...
is there any difference in the ohms required to operate the fuel gauge for the under seat tank V/s the rear mount tank? or a better way to word it...
was digging around looking for something else and found a hat channel source and thought i would pass it on:D it is listed under m38a1 parts, and...
ok searched and got half of the anwser, now for the other half:) worknig with a 1970 f134 spedo. one wire for the amp light goes to ign switch...
getting ready to install a d27 in place of my d25, and i have two questions. first question is the knuckle seal, does the same seal fit either or...
yes i know its been discussed many times over, and i searched, but my question is have any of you did it and kept the orignal steering colum? i...
i searched, and have done alot of reading, and know more than i didR) i have noticed on the d18 with single shifter when you put the transfer into...
just got done cleaning up my timing cover and the front seal looks really weird, just currious if it is different on the m38a1 or the same as...
any one know what the engine to pto ratio is, 1st,2nd,and 3rd gear....... never mind on 3'rd it direct or 1:1,know this has been some what...
model#41... have been told that it only fits the pickup and waggy, not enough clearange from the frame, any body shed some light on this? any...
been having all kinds of stuff turn up between the grille and radiator:mad: leaves mud etc:roll: i know they use to make a heavy screen type deal...
Separate names with a comma.