I have a Levies edition 7 parts jeep. No title so I'm not doing anything with it other than parts. I think it is an 84. Anyway, I finally...
So my Uncle purchased a 94 Jeep YJ. When it passed away he gave it to my Dad (his brother). My dad has had it for years and is not in his upper...
Thinking about a battery ratchet. I have a couple of air powered but they are loud and the cord gets in the way. I know they don't have a lot of...
I'm looking for a code reader. I want one that reads just about everything, engine, computer, ABS, etc. I see a whole lot of price range...
About done collecting parts to start a new build. CJ5. It will be mostly stock. I need your opinion on axles.... CJ5, 304 t150, D20 Plan on...
I picked up a never been on the road glass tub today. It is a CJ5 tub from an unknown manufacture. No holes for a top, no holes for a dash but...
I have always wondered about strapping a frame. I don't understand how this really helps much as compared to boxing the frame. Or even adding...
Well, my old Sears jack has seen better days. It's not even a craftsman. Just "sears". It still pumps but when I try to lower it it suddenly...
I have a gas tank that had a little surfact rust. I cleaned it with solvent and some nuts, bolts and drove around for a couple weeks in the back...
So I mentioned to the wife it was time to get a cage built for the Cj6 project dealie. Wife askes and I tell her I can order a basic kit for...
Ok so I make something out of metal. After its all welded up, how do you guys finish it? what do you prep the metal with? Prime with? Paint...
OK, so I picked up a metal band-saw a few weeks ago for $100. I asked your opinion and did research and while it is not an awesome band-saw...
I have a tilt column out of a CJ. It is wiggley and has some broken parts inside. I was going to send it out to have it rebuilt. Any...
I am trying to figure out how to get a post 76 column into a pre 76 CJ6 tub. I am trying to adapt the brackets to the tub. Is there anyone that...
'76 and up frame, why are their two holes? A smaller one and the larger one? And why is the larger one so large? [IMG] Current plan is to...
The tranny/trans is on the motor. I need to get the motor angled in the frame. Below is some picts. I used a level several places so you could...
Luk clutch kit. Need to install a pilot bearing in AMC V8. In the FSM it says to soak the new bearing and the lubricating wick in engine...
As it says. I need the seal that goes into the front bearing retainer. All any local auto parts can find is the one for a Ford. The Ford input...
This should be simple. Bolt the Jeep T18 to the Jeep bellhousing. 4 bolts. Well one stud and 3 bolts. So here are the problems...... 1 -...
401 that used to have an automatic. 79 Jeep CJ T18 I have a 401 flywheel and all the little parts. Is there any reason I can't go to the...
Separate names with a comma.