if no cracks and/or can be rebuilt it's worth $. what it's worth? whatever the next owner will pay for it but it's worth something. don't...
i got lucky with only having a dozen holes to fill and a couple of dents to take out. prob the only part of my rig that was left alone. i did...
no prob if your rig was an early enough '46 or a column shift there would have been 3 dash plates so 12 little holes on the pass side.
.02 but just go over to g503.com. if it's truly a gpw block they will drool over it.
48 2a but should be the same [IMG] [IMG] the 6 little holes on the right side of the dash are for the dash plate [IMG] dr side side:...
oh forgot the clutch tube needs to be moved too. your best bet is to find a parts rig with a 4cyl t-90/18 combo and just pick it clean.
x-mem needs to be moved back about an 1" or so. if your running a mb/gpw tub your floor is going to need to be modified for your t-case...
can the springs be flipped around ?. no idea if they have the same bushing frt to rear or designed for one direction or if the clamp on the other...
ooooh... good call.
looks faaan-tastic! maybe a black frame, black wheels with red sheetmetal? a good medium stain on the wood. wood bed rails no higher than the...
i'll shoot for 3a no key coil holes in the dash. check to see how long the rear wheel well housings are... if they're still original. 32"...
yep a tag behind the frt bumper dr side on the inside of the frame rail and on the firewall next to the air cleaner...
it's crap and i'll give 600 for your time in finding it.:D restore! or make some money off someone who wants to restore it.
x2. just got mine back together a couple of week ago.
just saw all the pic's on the g. that thing is fricken awsome. if you can remember it's not a show car u will have a blast fixing her up. my...
Mike C is 100% correct and it sounds like u know that. if it's a ford part somewhere it will be marked. somebody on g503 has compiled/is...
i think gpw's had rivets mb's had screws. i want to say they are stamped like a coin and then painted. then the rigs numbers, weight, were hand...
prob late on this 1 but i used some wd40 and move it in and out until it moved freely. i had a lot of rust/metal come out of the hinge. it...
i stretched my seat frame 2" so i just welded a nut into the floor and made this. [IMG] [IMG] [IMG] nothing like that latch setup but should...
sounds like u did a spring over... with that much lift (around 9") your going to have issues... problems with steering, caster,camber, pinion...
Separate names with a comma.