Geez, I have a MC 2100 and love it! Four years with not so much as a hiccup.
Can't remember the brand of the one I used, but for my 73 it's 15 gal capacity.
I have a complete kit for a jeep 6 cyl from Montgomery ward that's been around my Jeep stuff for about 10+ years. I did install a Pertronix on a...
If either JBScat or yellowjeep79 still have their parking brake assy, I'd be interested. Can't seem to see how to PM, sorry.:(
I had the same problem even with new mounts. Turns out it's a common situation with the early Jeeps. It was suggested to me by member "Tim", that...
I had the same thing and Tim suggested the factory fix of placing a 3/8" thick shim between the right hand axle spring pad and the spring. This...
I had a similar problem in that when my 258 was hot after running, the gas would vaporize when the engine was shut off for about 15 min. I bought...
I know on my '73, it's just metal to metal contact. I adjust both tensions by adjusting the bolts. This is the way it's been since I've owned it...
That's correct.
Looks pretty similar to one installed on the front of my 73 CJ that came from here... http://www.thedirtworx.com/
The adapter passages are tapered to make the carb bores on top blend into the ports on the manifold. If you flip the adapter over, you will mess...
Tim, good call on the primary positioning.:iagree:
This is the 650 Holley that goes on that manifold without an adapter. http://www.ebay.com/bhp/holley-650-spreadbore
Yes, the lower is connected with splines as well. I'm just not sure if the splines have a flat spot that would prevent sliding it on at a...
I don't see a concern with the lower bushing or washer when rotating the upper shaft and wheel, if I understand your question correctly. The horn...
The place that the bolt goes in is a grove that goes around the shaft, if I remember correctly, so it will always be in alignment.
I don't have the Weber on my 258, but I put on a 1982 intake/exhaust, that is also water heated, and had no problems hooking the water system. The...
After re- reading your posting, it looks like you might have the kit, just the incorrect one. In that case you can disregard my previous answer.
The only time I mounted a Grant wheel was on a boat steering system. I had to use one of their wheel adapters to fit my application and then the...
If the connector is getting hot and it's draining the battery, you could have a shorted or stuck starter. Disconnect the cable from the starter...
Separate names with a comma.