first, according to my book the rear tapered hubs are only torqued to 150 lbs. also is this just a dust cap of some type or is there suppose to be...
well i finally had to replace my rear axles, broke one and twisted the other. any way i cant find what the bearing cap bolts are suppose to be...
i have my original M38A1 tie rod, ends were shot, so i bought a complete setup for a cj5, much smaller. now i have a chance to buy a complete set...
well i finally did it, converted from my old generator to a one wire 100 amp alternator. what a huge difference. now at an idle i still get 14.87...
i noticed yesterday, when adjusting my electric choke on my edelbrock 600 carb, that the choke has a small hole under the black plastic housing...
i just installed a lockright in my friends 53 cj3a. his jeep is stock except for 12 and one wire alt. i was told that the t90 trans is n ow the...
i just installed a lockright locker in my friends 53 cj3a and when trying to do the test, push one wheel forward to lock then reverse the other...
im installing a lockright in the rearend of my friends 53 flatty with the dana 44 rearend. does anyone know the torque specs for the ring gear.
does anyone know of a place that makes baja doors for a 53 cj3a. i can find full tops but not half doors.
well looks like ill be installing a lift on this 53 flatty. karge said that skyjacker doesn't make a lift for the older short springed jeeps, said...
im going to be putting 33s on my friends 53. when i drove my 55, with 33s, the old bell crank steering killed, it didn't help that i had one of...
well ii got my new gauges and speedometer form karge today. the only problem is that the gas gauge reads backwards and only moves the needle maybe...
im replacing my front wheel bearings and races. should i be able to tap out the old races and install the new one myself or do the new races need...
the owner of the 53 willys im working on wants to put a locker in the rearend and lift it. ive got rancho 2&1/2 inch front springs from my 55...
well i removed my rear axles today, bearings look good but the end of each axle has a nice scratch in it, not the spline but before the splines,...
im looking for the pcv valve for this old 53 flathead. i have the one that screws into the manifold and has a 45 degree angle fitting that...
well i brought my new water pump and fuel pump home today, the fuel pump wasn't to bad to install but the water pump seems to have the pulley...
i just found, and mounted, an old sparton turn signal mech. it has the little rubber wheel that rubs against the steering wheel so it will turn...
i bought some decals for the dash, 4 speed and the transfer case, high/low range and overdrive decal.i swore i bought them here but i cant find...
first i need to thank everyone so far for there help with my work on my friends old 53 flatty. now i need to know how to set the timing, ill be...
Separate names with a comma.