Anyone have any pictures of the frame of a 74 Cj-5,,, Iv driven this thing 18 years with the same 304 in her,, The hard top was holding the body...
Im planing on using my hanging pedals from my 74 CJ-5 on my CJ-3B body swap ,, So I should check to see if the springs are in place & if they are...
But where was the charcoal canaster mounted ,, My 74 was a real rusted up mess ,, it fell apart as I took the hard top off...
I am installing a 59 Willys CJ -3b body on a 74 Cj-5 frame & sure could use the pictures of the fender well baffles.. I need to add a rollover...
Well Im not using a XJ collium butt I am using a S10 chevy truck tilt collium ,, Im installing a 59 CJ3b body on my 74 frame I liked the ides of...
I bought a ez wire harness for my 74 with a AMC V8 & told them I had a S-10 tilt column & needed the wirng for that & it came with everything I...
Ditto on the sun pro ... Easy hook up,,, Wow thats a nice looking Cj I dont think mine looked that good from the factory,,,
Back in the early 70s I had a 64 Willys truck with a t18 tranny in her ,, sloppy wasnt the word for it ,, I pulled the top off & braised some...
See what you JEEP is doing with or with out the Overdrive,,, Any kind of gear ratio before you turn wrenchs & change tires,, Guess you have to...
I've got a 74 CJ ,, When I bought it the PO put bondo on the angle at the very bottom of the roll bar ,,, After a screw driver & a hammer I found...
Anyone ever use Never Seize,, I just put a dab on the end of the shaft & it lubes good & dosent get hard or brake down from any friction heat,,,...
After looking closer at mine I figured out whats wrong ,,, The cotter key that I pulled out only had one leg on it ,, Picked a needle nose vise...
Thanks a bunch I was just about to go out & get a bigger hammer,,, I pulled the cotter key already ,,,, Ill give it a shot ,,,
I'm working on a 74 CJ-5 .. Taking the the last few things off so I can get the cowl section off the frame,, I've cut the old rusted body off in...
Id dump all the oil out of her,, or it might be all over your bed or up in the heads or valves when you get it home,, Mine sit in the back of my...
Im building a 1959 Cj-3b on a 1974 Cj-5 (that had a 304 in it) frame & running gear, I looked throgh 14 pages of Chevy & Fords being added to a...
They made them Surreys in 3 diferent collors Pink, Blue & Green,,:beer: Check them out at this websight,,,,...
Im using a EZ wire aftermarket harness for my 3b Project & they make it very easy to install & repair with markings on the wires every 5 or 6...
Well that compsite decking should hold up to any weather,,& that would look good might have to think about that for my Cj-3b,,:beer:
Next time you take the head off,, check the surface of the block,, It might need to be machined to make it flat..:coffee:
Separate names with a comma.