I used the stock skid plate with the 21 gal poly. You have to do a little fabricating when it comes to the tank strap. I just welded a couple of...
Changed over to a 21 gal poly. Wasnt sure if I was going to like it but I do. Less time at the pump and a little more weight on the back end....
I switched to a flaming river tilt column. It wasnt to difficult to install but I made a custom dash so I am not sure about installation on the...
Was I supposed to take the distributor out before working on back-up lights? I thought just taking the negative off the battery would suffice......
Ok. I am lost. I was installing some back up lights yesterday. I pulled the negative off of the battery then put it back on to check for power...
Thanks. Got em working!
Thanks Hudson and Timgr for the quick reply. I will definately trace that hot wire.
I am by no means even an amatuer at electrical so this may be a stupid question. I finally got my rear bumper/tire carrier done and I am working...
I could never find the round plugs for my '74. Repro at least. You can always check junkyards. I ended up using tweeters that I bought at Best...
I have the stock fuel sending unit hooked up but I think that is the problem. I am looking for the tube type now. I am replacing the tank with a...
Wasnt concerned... I have Equus gauges and my fuel gauge needle bounces all around when off road just thought it might help with that. Not a big...
Has anyone seen these foam cubes to put in a gas tank to prevent sloshing? I was thinking about trying them but I wasnt sure how the fuel sending...
I took out my whole heater assembly and was planning on capping it off myself. Just not sure how to do it without allowing water to pool up top....
I had the same problem when I changed over to a 4bbl edelbrock. Bought a new cable and it didnt fit very well. Had to make some adjustments....
Thanks everyone. I will try both and see how I like it. I tow fairly often so I might stick with the diode approach. Thanks again. B
I put a Flaming River Tilt Column in my 74. I had to buy a mounting ring from flaming river to mount to the dash and then I used a larger U-bolt...
I have replaced a few clutches in a few different jeeps and thinking back to the first time I did it I think the easiest way to do it is to drop...
I hooked up a trailer light pigtail to my existing LED taillights on my 5. I plugged in to my 05 Ford F250's existing trailer light plug. The...
No it runs bad hot or cold. Seems to run worse hot. ??? Frustrating:mad:
Yeah I checked the distributor. It was tight. I even marked a line on the hold down bracket and the distributor to make sure it wasnt moving. I...
Separate names with a comma.