OK, I have my 74 CJ5 up for sale to make room for some other Jeep projects. It has PS that I did. All steering was replaced and is now tight. The...
Got my eventual 360 running. Problem is there is no oil pressure. Took the intake off to swap to a 4v and noticed little to no oil in the valley....
Ok so I have a 1979 360 from a waggy that I'm starting on. It had a TH400 behind it. I want to take this engine and drop it in my 74 CJ (I6 258)....
So I adopted two Wagoneers - a 1979 and Grand 1984. Both 360. I want to use one for the CJ (258 now) and rebuild the Wagoneers into one good one....
I have a vibration while in motion and in the gas. What I have done so far, Checked and adjusted the timing and carb - not here. Adjusted...
Is there a two rubber seals between the windshield and cowl. I put a new one on the bottom of the windshield but is there one to match on the...
Quick questions, I turned the flywheel and decided to throw a new OEM clutch set in. After buttoning it up there is a lot of pressure on the...
Looking to purchase a tube bender for work shop to bend large steel hydraulic lines. Also as a added bonus, would be nice to bend tube for roll...
Thought it was a sticky lifter in the 258 since I had it. Seafoam it several times and she runs great. Just a tic tic on #3 cylinder. Lots of play...
Is it correct that the diameter of the hole for the output shaft of the PS box on the pitman arm is the same on 72 - 83 CJ.
Still chasing out last wander problems. When I put on the ProComp lift I added these shackles and new spring hangers on the front. When someone...
Looking for ideas in strong, but simple family bars for the rear. Adding front hoop and spreaders this weekend and want a safe setup for the rear...
How does everyone address the trailer plug. I have the 12 or more pin military plug for the trailer. It is also still 24v. Do I remove all wires...
Just picked up a 1966 M416. Setting it up for my 74 CJ5 to pull. Without any load do I want the trailer tongue to be level with the ground? I'm...
Project done with the PS upgrade and WOW is it one finger driving. Is there anything to tone this down? It is a 74 with a 83 CJ5 PS setup.(Still...
I thought I was done but as I finally got the Jeep out for a good test drive this evening the steering is so tight as in hard to turn. It feels...
I have an old bus wheel that has many cracks and needs to be replaced. Since the PS is on and working I figured I would go to a smaller wheel - ie...
Going from a single groove to a double groove crank for my PS. If I remember right, I put it at TDC, remove large bolt, slide off old pulley-...
Can you twin stick a dana 20 72-75 without the forward extension like the Bronco? Many advantages for a mild less then wild trail rig? -D
Before I start on the construction of my sliders, I just wanted to make sure that there is nobody that builds half way decent sliders for and...
Separate names with a comma.