Another approach would be to cut a hole in the wheelhouse just big enough so the seat bracket slides through it,,, When the bracket is far enough...
Misstype,,, should have typed 4 WD hardware glass body
i CAN'T HELP WITH THE MOUNTS, BUT THE VALUE OF A GLASS BODIED JEEP ALSO DEPENDS ON THE QUALITY OF THE BODY ITSELF,,, i USED A 4WH GLASS BODY (IN...
Earlier today, there were more replies to this thread,,,, where did they go???????
I believe it will fit, but you will end up with top fitting problems,,,
Install a ground to the frame and the problem might go away!,
Waayy back in the mid ‘80’s, after the floors and other body parts were disappearing because of rust, I rebuilt my ’75 CJ-5 using a fiberglass...
IRISHRALLY, Is this going to be your first Jeep????
I didn't want to Pirate the thread posted by ROXJ, even though this is simalar. My '75 with a 285 sometimes smokes on start up, but as it warms...
but what happens when you mount the fender on,,, doesn't it interferr with the bat try brace????
iF YOU CAN GET TO IT THROUGH THE FUEL SENDER ACCESS ON TOP, YOU MIGHT TRY A STAINLESS STEEL BOLT AND NUT WITH NYLON WASHERS,,,
When I built my '75 with a 'glass tub, I got blue colored battery cables with eyes on both ends,,,, went from the plow relay to the starter relay...
How about one of those pop up type tents with sides??? It would cover the CJ with out really touching and rubbing that nice blue paint. It would...
i THINK IF YOU REPLACED THE VAC ADVANCE, YOUR PROBLEM WILL BE SOLVED. I have had to replace the VA in my '75 a few times,,,,
I used the grote tail lights listed above, but added the "tractor Lights" with the rubber housing for back up lights,,, I removed the mounts that...
>>"I remember my neighbor who works for well now Navistar then International trucks putting powder laundry degergent into his cooling system and...
If the rust isn't too bad, I have found that rubbing it with a wad of dry aluminum foil works quite well!!!
iT TOOK A WHILE TOGET TO THIS,,,, tHANKS FOR THE OFFER,,,,,`
iowa, I also own a 75 cj-5,,,, AND a '52 MGTD !! contact me at steven.p.wincze@power.alstom.com
Is the heat riser working properly ????
Separate names with a comma.