Pretty sure I used a larger hole chev bell housing. Sounds like I may need to find an sr4 bell housing and just see how it fits with the jeep...
Thanks Nickmil. I have a good dana 20 for him with bronco gearing and factory twin sticks. Your comments bring a couple questions to mind....
Sorry. He has a 258 cid.
I have someone interested in purchasing a T-18 from me and installing it into a 1981 CJ-7 that currently has an SR-4 transmission. We need to know...
The T-18 that was in my 75 had a 1" spacer that enabled the fitting of the dana20 transfer case to it.
How far are you towing it?
On the high steer arms, we drilled the knuckles out for 5/8 studs, and just used wheel lug nuts on top since they have the taper. Probably...
Well, you need to determine if your regulator and generator are 6 or 12 volts. A 6 volt charging system isn't going to charge a 12 volt battery....
I did post it on the G503 board. I spend a lot more time on that board than here. But no one really knows this animal. It is a t-84c-1a. I am...
Just make sure the wipers do not hit them.
I am in the middle of rebuilding a T-84. It is an early 1942 ford gpw model with the fill/drain on the right side. I have found that it needs 2nd...
There is no such thing as a compound angle on a drive shaft. I know what you are trying to say, but an angle is just an angle, and it doesn't...
I think I understand your logic, but pick-up trucks still seem to have a lot of axle wrap problems even with their stiff springs. If you do try...
Well, remember that without a double cardon joint (Using just single joints) the angles on both ends of the driveshaft need to be about equal or...
Are the sylvania silverstars available in auto parts stores?
Make it 3 to 0. I have wheeled them all. Two simple thoughts. 1) Obviously anything older is more collectable as original. 2) The YJ makes...
Just replace the rear output housing on the t-case. Quick, easy, and comes out as an assembly. Cheaper than shipping a whole t-case.
Looks like a 43-44 MB tub with lots of changes hiding some clues.
We probably have wheeled in some of the same areas. Don't screw around with changes that make it go faster on the road. Tow it. Get home safely....
That thing actually looks pretty neat. I would finish what somebody else started!
Separate names with a comma.