When did Willys (or Kaiser) finally do away with the left hand threaded wheel studs on the driver's side? My '47 CJ2A has/had them, but my '68...
Is there a database anywhere out there that might tell me where my '61 Willys Wagon was originally sold or registered in the past? Since it...
I'm putting a 231 intake on my 225 and am at the point of plumbing things. The 225 just had a PCV valve on the passenger's side valve cover. The...
Which Pertronix Flamethrower coil should I be looking for? 1.5 ohm, 3 ohm... I've already converted to Pertronix in my distributor, but now I'm...
What are your thoughts on swapping a Holley 2245 two-barrel carb onto a Dauntless V6? Why am I considering this? About 15 years ago I cracked...
After 10 years of use and abuse, the starter on my Buick V6 quit. It began to randomly just give the dead solenoid "thunk" and no spinning of the...
After several months sitting, I went to start up my 2A. It cranked but didn't fire. I kept trying it until it stopped cranking, and it's not the...
While looking through the GSA auctions online, I came across some 1/4 ton, round-fender "jeep" tailers. The description stated they were made by...
I've been struggling with my HEI swap for a while now. It's an on-again, off-again priority depending on my level of frustration with it. I can...
While working on another project (installing a Delco 10SI alternator into a tractor) I realized the wiring on the back of my alternator in my 2A...
I noticed the other day that it looks like the geometry of my front end is changing. Take a look at the pics. Pic one is after backing in to the...
On a stock '68 CJ5 alternator (Motorola with external voltage regulator), which post would be considered the "field" post?
It's been a while since I started my console and I had expected to get it in before now...but that's how life goes. Today I finally got around to...
After too much thinking and not enough action, I started my ammo can console yesterday. It was really spurred on when I scored a good Pioneer...
This has been bugging me for a while, now, and I need help. I swapped in a stock '68 225 Dauntless (with points) into my Flattie. I freshened it...
I'm in the process of swapping HEI into my 225. I got a used OF dist off eBay and read the tech articles by Howell and Bucholz in the Tech...
I'm swapping a 231 intake onto my '68 225, and I'm looking for a part number for the intake gasket. The intake is a later one, with the EGR port...
A question for those of you running a 225 in a Flattie: I just now realized a goof I made when I swapped in a 225 into my '47 CJ2A. I spent a...
Introducing: The MEGA Heater...50,000 BTUs of school bus heater fun...! Great idea (I thought, anyway) for kicking some heat into my...
A couple of years ago I taught myself how to weld, and sometimes my welds look decent (it's all realitive). But, for the most part, I just get...
Separate names with a comma.