Not so. Wagons have offset rear diffs.
Thanks for the input. I'll keep digging and see what turns up.
Thanks for all of the replies. I swapped out the lefties on my 2A a long time ago and am planning on the same for the Wagon. I was surprised to...
When did Willys (or Kaiser) finally do away with the left hand threaded wheel studs on the driver's side? My '47 CJ2A has/had them, but my '68...
Is there a database anywhere out there that might tell me where my '61 Willys Wagon was originally sold or registered in the past? Since it...
I'm putting a 231 intake on my 225 and am at the point of plumbing things. The 225 just had a PCV valve on the passenger's side valve cover. The...
Thanks everyone. Guess I'll go with the 40511 (oil filled).
Thanks for that tech view. I guess mine is an earlier one, based on that bowl vent shown. Still - it strikes me as very similar to the 2G and...
Which Pertronix Flamethrower coil should I be looking for? 1.5 ohm, 3 ohm... I've already converted to Pertronix in my distributor, but now I'm...
That's pretty much the one. Not at all like the Holley I had in my old Blazer - totally different fuel bowl.
Thanks, timgr. That's the input I was looking for, and performance issues I want to avoid.
What are your thoughts on swapping a Holley 2245 two-barrel carb onto a Dauntless V6? Why am I considering this? About 15 years ago I cracked...
Thanks for help everybody. I'll be crawling back under asap. Didn'tknow anything about a starter brace. Mine didn't have one when I got it.
After 10 years of use and abuse, the starter on my Buick V6 quit. It began to randomly just give the dead solenoid "thunk" and no spinning of the...
Sweet - aircraft lap belts! Nice find
I disagree...you should send it to me! Seriously, though - KEEP IT! Think of the options in gearing both on and off-trail it gives you. It adds...
Took the starter out and jumped power to it...functioned fine. So, I pulled the remote solenoid and rewired from switch to starter and BINGO! I'm...
It's not the battery. That was the first thing that got replaced and the gound cable connection freshened at the same time. Now it won't even...
After several months sitting, I went to start up my 2A. It cranked but didn't fire. I kept trying it until it stopped cranking, and it's not the...
Check your steering linkage clearance at full turn. My steering linkage hits the front of the trans, so I lost a bit a turn radius.
Separate names with a comma.