I did not read all the posts so maybe some one already suggested this but here are my 2 cents. Timing chain and gear lose ? or maybe missing a...
Thanks for the good info ! I am guessing the reason to remove the rear drivshaft is to keep the tranny from spinning ? Why not just keeping it...
Ok, so no need to take off the front drive shaft ? Just leave transfer case in N and hubs on free ? and keep the steering wheel free. Do any...
I am thinking of towing my 1970 CJ5 3 speed behind my cabover camper dully set up. I am wondering the best way to do it. I assume everything in...
I put side exhaust headers on my 1970. When it wears out I will go back to the original exhaust manifolds with a custom dual exhaust. Side...
I just had my carb rebuilt. It seems to run fine but when I shut off the engine a small amount of gas leaks out from around the throttle shaft...
KRAGE sells the screw on connectors. Much better and cleaner
I replaced my old one with a plastic one. The original was cardboard.
I just put a new one in my jeep. Only 99 bucks plus shipping. Brand new, fit perfect. New sending unit too. It all went good. My old tank...
I wanted a jeep since before I was old enough to drive. Bought my first one when I was forty years old. I paid to much and it needed way to much...
I put the skyjacker soft ride on my 1970 and it seems to work fine. 2.5 lift, easy install but it does ride stiffer than I though it would.
The big black rubber thing on the back of the carb is for the smog pump. I just plugged mine when I took off the smog. The small nipples are for...
I busted my timing chain cover a couple of years ago trying to replace the water pump. I could not find one anywhere. The ones I did find had...
Ok, I tried grounding the temp sender wire but nothing happend. The needle does move a little. The new senser I put in is about as big around as...
Ok, I got it. I will try it tonight. And if the needle does not move than does that mean the gauge is bad.................?
Which side of the sending wire should I ground? The sending unit side or the gauge side ?
Just fired off my jeep last night after replacing a cracked head, carb rebuild, new gas tank, installed new EZ wire harness and a bunch of other...
I am just about finished wiring in my new harness. I went with the EZ 21 kit. I freaked out when I started but it turned out it was not that...
Great advice from folks who have done it. I will tear out the old and start new. Did you guys replace everything. Some of my wires are still...
I got my new EZ wire kit and pulled of my dash and got kind of dizzy trying to figure out where to start. Is it as hard as it looks. My old...
Separate names with a comma.