While installing my Herm Ford Reverse steering box, I have noticed it is very close to my mechanical fuel pump for my Buick225. I am considering...
I have been working on installing my Herm Reverse Ford steering box on my CJ3B with a NT Dana 30. I ran into a problem with my drag link, but...
I have been planning on using Herm’s Reverse Ford power steering kit on my 3b for some time. While installing today, I found out that the stock...
I have a question that I can not find the answer for. Should by transmission/transfer case be level in the frame (my rear output yoke is down 5...
I am finishing up my Dana 30 swap and can’t be happier with the way it is turning out. I can see the width difference in between the front and...
I am all most done with my dana 30 rebuild/install to replace my dana 27. I have run into a problem trying to get the axel out far enough to...
OK, I am starting to put my Dana 30 with drum brakes back together. I broke my cardinal rule of taking photos of everything and find myself in a...
I am moving from a Dana 27 to a NT Dana 30 for by build. The question I am trying to find the answer for is will the Dana 27 spindle and hub...
Has anyone installed a rear CJ5 fuel tank on a CJ3b? I know I will need to remove the draw bar and install a custom rear bumper. Will a standard...
I am looking at selling my Bantam. Its in good shape, MN Title, Spare Tire, and I have bows (bent oak only/no steel). Anyone know a rough value?...
I have the old style solenoid pack on my 8274. I am in the process of rebuilding the winch and trying to find repalcement soleniods. What is...
Those who have installed a SI10 or a SI12 in their dauntless, where did you clock your wiring harness? Up, down, drivers, or passenger side?...
I am working on getting my 225 together in my 3B frame. As I go through my parts and planning out my work, I noticed that I have two water pump...
I am sure this is an ignorant question, but is there anything special about exhuast manifold bolts? Specifically 225? My motor did not have...
As I have indicated before, by 225 was missing a few items when I got it. One of the items missing was the starter. I purchased a new starter...
Dropped my buick 225 into my CJ3B rolling chassis this weekend. Looking at getting the motor started to see what I have and if I need to rebuild...
I have found a narrow dana 30 out of a 79 CJ7 which has 3.07 gears. I would like to pick this up to possibly put under a flat fender but need to...
I am working on putting together a saginaw swap for my CJ3B. I have found a DJ steering column that I am thinking of useing. The question that I...
I have a set of 11" backing plates for my CJ3B project. Has anyone ever powder coated backing plates or is it better to paint? I have have 3...
Sorry to hijack the thread, but does anyone know were to find a replacement for the connection between the oil bath aircleaner and the valve...
Separate names with a comma.