Horsepower TV will be building a AMC 360 on next weeks show. What's interesting is they typically finish with a dyno run so you get some real...
Does anyone know a source for really good pliers to remove the split rings on a T18 front and rear bearing. The larger rings on the bearings...
Rebuilt a 72 360 for my CJ. Block was bored 30 over,crank turned etc. I assembled the engine and went to start it today and wouldn't start. It...
I have re installed my 360 and am getting everything back for a test run. Last night i installed my clutch linkage and stepped on the clutch petal...
The gasket has 2 sides, one side is shiney silver finish the other side is dull grey. Which side goes where, Im guessing the silver side goes to...
The brake lines from the master cylinder to the combination valve are shot. I have changed from the original MC to a power unit off an 81...
Looking for a source for the seal and boot for a steering shaft bell coupler on a 75CJ5 wi manual steering, I cleaned up the internals and removed...
I am rebuilding a 360. From the cylinder heads casting I believe it is a 71 or 72 motor. The harmonic balancer rubber looks about to go, so I'm...
When installing the pistons and rings in the block I usually put a couple of squirts of motor oil on the rings and a light coat of assembly grease...
From a previous post I see the Autolite spread bore is not the same as the Q-Jet. So if I understand I can't use a Q-Jet in place of the Autolite....
I asked for a small parts washer for Fathers Day. Assuming I get one what to use for a cleaner. Back in the day we used something we refereed to...
I have a new front hub for my 75 CJ. The holes in the hub for the wheel studs are .580. The replacement studs have a diameter of .634. Both hub...
This was covered late last year in either this forum or off topics but I can't find it. My ACE Hardware used to have a really good assortment of...
My project is a 75 CJ5 with a 304. Besides the 401 what could I use. I'm thinking power steering, front disk brakes, possiblly AC for onboard air,...
I have an older Campbell Hausfield AC that is pretty tired. When I painted Rusty it wouldn't keep up so I ran this one and a small portable...
I was anticipating a wheelhouse notch since the CJ5 was prettymuch apart anyway, but I got to looking. Notice how long the steering colum is....
I am repainting the tub on my 75, After reading several recent posts about bed liner materials it appears most-not all, think there is too much...
Looking in both the Eastwood and Summit catalogue, they list an epoxy primer and a urethane primer. Eastwood lists a sprayable filler. I...
Starting rust repair, lower side completely rusted through. It will be covered by some sort of body armor or sliders but wanted to repair first....
Cause It's done. [IMG] [IMG] [IMG] [IMG]
Separate names with a comma.