Ah - I think I solved the spring conundrum. The book lists 57-64 FC trucks, which were the ones with wider axles and other changes. If I have a...
Hmm, the frame does curve up in front of the front axle. [IMG] [IMG] I'm a bit confused, though. My copy of Jim Allen's Jeep 4x4...
Are the body mounts different between a CJ2A and a CJ5? This Jeep had a CJ2A body tub with it, though not attached. I haven't checked, but I...
Actually, I do have another shot of the front: [IMG] Also, note that the springs are CJ5 springs. The front ones are 39.6 inches long and the...
Here are a couple photos of the frame. First the front, and then two of the rear. I don't have a good shot of the whole thing. [IMG] [IMG] [IMG]
I don't think it's a shortened FC frame, because the rear springs are CJ5s (46") rather than FCs (52"). I can't think of a reason someone would...
I have a mystery frankenjeep that I recently picked up. I got time this weekend, so I went out and did some measuring of its frame. It has a 2A...
There's an MSN group dedicated to the Datsun/Nissan 720 pickups, and they have a board specifically for the SD22 engines (I know about it because...
The plate looked aftermarket. No numbers stamped in it, and not painted. I did some searching, and according to the fine folks at the...
Huh...like I said, I'm told this engine came out of a 2A already - and one of the parts I got was an adapter plate. Maybe the previous Jeep had a...
The engine was out of the vehicle since I got it, though I'm told it came out of a 2A, so it should fit. The only reason I'm using it rather...
Like the title says, I'm just embarking on a project to build up a CJ-2A. I'm starting with the following components (thanks again, George!):...
Separate names with a comma.