Window #1 installed, awaiting final trim
Window #2 during installation
Window frames getting pre-painted
Window parts made of milled White Oak
Front end loader doing front end loader stuff
Rough sawn White Oak
I started using Rotella in my Dauntless before I sold it, great stuff. Started using it in my Cummins as soon as I bought my truck a few years...
Dude. Your're making the rest of us look bad! Outstanding build!
I picked 6.0 for the durability and diesel-like torque, but also for the 6L90E that comes behind them. Searched all over Griffin's site,...
Just sprung a leak in the radiator of our trusty 2007 JK with 3.8 V6. This Jeep is going to get an LS 6.0 transplant in the near future. I would...
Since you've already pulled it, I would get a pint of urethane and spray it. Engine enamel thread: Dauntless Engine Enamel Paint Paint chips:...
Wheel Identification ? | EarlyCJ5.com
Excellent writeup. There used to be a section here called "Tech Articles." It was a tab on the main page of the site, separate from the forums....
Hope this helps: [IMG] [IMG]
Factory spacers that I was talking about: 4spd Ramblings | Page 3 | EarlyCJ5.com T-14 crossmember with a T-18 sitting on it: 4spd Ramblings |...
I knew there was something not adding up there. Forgot about the civ/mil aspect. Checked my notes, that pic I showed you was definitely a '63 CJ....
Re: New Jeep! Nice
She went on to start a new chapter today without me. I bought this JEEP as a newly divorced single dad, and it saved my life. All the nights...
There is enough room to mount a 7 blade fan directly onto the water pump pulley, but not enough for a clutch fan.
What ever happened to this build?
Separate names with a comma.