I have 2 receivers ont he front of my cj-7. Makes a great plow mount without losing ground clearance.
Deffinatly be good candid camera stuff. Get it marked so you can only see it from the pass seat......then get a shot of the look onthere face when...
Re: V6 Cutting out at cruising speeds? that may solve itR)
Re: V6 Cutting out at cruising speeds? explosives............R) Wow, there is really nothing you haven't tried.
Re: V6 Cutting out at cruising speeds? Have you considered something in the valve train? Bad or failing hydraulic lifter? may show up at max load...
Yes. Different application and not quite the quality of DOM. I use it simply because the steel in Pipe is just not a very good quality and not...
I like to use pipe sized steel tube. notice i did not say pipe, just pipe sized. Get the stregth of steel tube, less cost than DOM and the...
I agree that in terms of what I have been exposed to (the adapted 4.3 GM system I currently run on my CJ7) and the GM origins of the engine we are...
Finally found a decent source of info. The Ford EFI uses a stator moduale inside the distribuor with a stator "wheel" for timeing. The wheel...
Oh I spent 15 minutes typeing and hit the bak key on the stupid 5 buttom mouse and lost everything.........
we need some sort of rpm feedback for the ECM to operate. We are talking about building a crank trigger to give a GM EFI the "rpm" signal it...
Oh and that CO2 tank yer totin around...........comes in handy for airing the tires back up after a hard day of drinkin.....uh wheelin. Dual...
:D
Buy a warehouse.................... we fabricators are netorious for being pack rats........:D if you have a really stubborn bolt broken off...
nice repair Lynn
2x6 is a bit of overkill. I cut the back 18 inches off my CJ7 and used 4 pieces of 3x1/4 bar to make a box frame, just cause it was handy. I...
As long as we are speculatiing..... with a 9:1 comp ratio we could realistically run about 8psi of boost safely without any internal...
thought had crossed my mind :D By the way, I did some looking at my dist cap, and the reson why it ran so terribly and I was confused as to...
I agree completely, Thats why I looks @ Ford. The ino I have so far is that thier TBI spark signal is off the Distributer shaft. Put a...
cool, That should make it easyer. I am still digging into Ford TBI's most common 3.8's are the 80's tbirds and cougars. I love diggin :D
Separate names with a comma.