mine works great! I used shortened pedals from a mid 60s chevy pick up{just some junk I had ].The booster came from ebay. the mount is just a...
Uncle BIll, try sticking scotch clear tape on the flat over the number,make sure it is nice and flat. most of the time it will pick them up.
check the spot weld cutters out they may help....
I like the one that you ordered because both cut in and cut out are adjustable. I used them on the shop compressors in the machine shop I worked...
Is your drag link at a steep angle? that will do that and bump steer too. as the suspention moves up and town the drag link will move (Steer) the...
Looks good! I made a front bumper/tank but it seems a bit small so I might make a rear one and connect them with 1/2' plastic air line.
on board air pics Front, rear and left side the funny looking triangle inthe upper right side of the rear(2nd pic) is a 1/4" recess for...
If you use a (Smooth)hammer/dolly combo don't place the dolly right under the spot you want to lower(hammer on as it is called) Unless It is a...
BULTACO? Did sombody say BULTACO? I havent seen one of those for quite a while.I once had a 69'Matador 250 and my cousin had a Pursang 250. I...
Where is the pinion on your rear differentail? If it is in the center you will have driveshaft problems anyway so now is agood time to avoid...
PCV carb, can or valvecover opposie of the PCV to any good filter I use a K&N. your valve covers are newer than your block. the old ones vented...
Re: CJ-3a grill Tellico has them part#DMC3149 they are likely OMIX-ADA
I will try for tomorrow or tuesday. I dont have any pics yet. It is about half tacked together. I need to make a gusset and a better alt pivot...
Re: To build or not to build? Builld it, it is a lot of fun and you know what you have and how it works. It is much easier to know where...
Thanks Chris, That's what got me restarted. I started once then got stalled. jzber, what side is yours on? My PS pump is high up on the left....
What did you use for brackets? I am bulding my own and curious what other people have used. What thickness material did you use and how did you...
Mine look like they were cut from a chevy pick up rear wheel top inner well corners.
Neat idea! I have one of the old style chrome ones with the thumb switch.HUMMMM
231 v6 Hydroboost, 11x2 rear, disk front dana 44s curent project is onboard air. Then wider front fenders.
Separate names with a comma.