I've been running 33's on my 1960 Dana 25 w/ Powrlock all over, including trails like the Rubicon. No probs, except when one time it tried...
You sure you want to put an extra 100 hp on an locked Dana 25 - especially with the super-low gears of a SM420 and 5.38's? OK, I admit I did it,...
Watch the year on the 350. I have a high compression version (pre-1971) and I have to run mixed race gas at sea level, but its great above 4000...
Diodes - 3 of them. Before that clamp-ons. I switched because it was so much faster to hook up and unhook that it made it a no-brainer to tow up...
The Jeep USM says tighten inner nut until slight binding, then back off 1/6th turn, put on washer and outer nut and tighten. Haynes manual says...
Yep, I'll bet it has to do with the lift, as a lift would allow the axle to move side to side more than stock. I'm going to check, but I'll also...
BDS tech support answers some of these questions: Yes the outside (between the twin tubes) is like a reservoir, and yes a dent could decrease the...
Upside down or down side up, aren't they still compressing and rebounding the exact same amount? I would think it would be a reservoir oil supply...
I recently installed a leaf spring/shock 2.5" lift kit on my 1960 CJ5. It made the rig much more comfortable than the old stiff spring packs....
Yep, a dues-paying member.
I didn't really want a full top, as I like the open air, but I wanted my stuff to stay dry. Besides, I don't think the Tigertop would have fit...
ditto what tumbleweed said.
These guys bought the Kayline brand : http://www.specialtytopco.com/ or something like that.
I was wondering how to do this same thing. But I wonder if the drain would be larger than what a DMM can handle before popping a fuse (hopefully...
go here: http://www.kinzers.com/don/landcruiser/transmissions/index.html
The decision may be influenced by length of the trans you are swapping out. I am guessing you will definitely be dealing with driveline lengths...
Re: Hub Puller? -------------------------------------------------------------------------------- The guys at the 4WD shop showed me how...
The knuckle needs thick stuff, but the diff just needs good gear oil. I use Sta-Lube Gear Oil #SL2472, GL-4/GL-5, SAE-80 plus a Lim. Slip...
BDS same as 4WDH? Well, they both have the same spring rate - F350, R375, both have bolt & cinch clamp, both have 6 leafs in a pack, both...
Separate names with a comma.