I'm about to put my 225 back in my 2a and am trying to decide what carb to use. The motor is stock other than a DUI distributor and headers. I...
I have been looking at different routes to take for an axle swap. Is the WT Dana 30/amc 20 the easiest swap? I found a set of scout 44s for $250...
I am pulling my 225 out to replace the existing motor mounts. The PO had done the swap and the welds and placement are ugly. Has anyone...
I have an opportunity to get a complete Scout II Dana 44 axle with the auto hubs for $265, or less without the hubs. Will that axle be an ok...
I have had this almost two years now and have only gave it a spray bomb paint job, some tires and have gathered up parts. Now it is time to set a...
Here are a couple pics of my Canadian military 101 trailer. I have definitely got my moneys worth out of it since picking it up about four years...
I was at a Jeep show this past weekend and picked up an Edelbrock Performer intake manifold with a Holley 4 barrel mounted on top. The carb needs...
I am trying to re-locate my battery to make some room and clean things up a bit. The engine bay is too tight with the 225 for my new battery. Plus...
Does anyone know of a good place to get a hold of Michelin trailer tires. I am looking to get a spare and at some point another set for my...
I am about to swap over another set of non welded axles with the same factory 5.38's. The PO had welded both front and rear axles into a sort of...
I just picked up a 47 CJ2A with a 225 V6 in it that a previous owner had swapped in. My stupid question is how do I know if it is 12 volt or six...
The one 47 CJ2A I have has a Husky overdrive on it. I was curious as to how this works and the shift patterns of the high low range as well as the...
I just got two CJ2A's one for parts with an L-head Kaiser Supersonic, complete with all accessories and the other has a 225 and is in great shape....
Does anyone know of a spair tire carrier that is made for my M101? I would guess that others would fit with the same bolt pattern. thanks
I am changing the fluid in my T14 tranny and Dana 18 tcase and was wondering what weight they take. Also could someone tell me the low/high ratios...
On my first test drive I realized I have no real brakes. I noticed that I have 11" drums in the rear and I believe 10" in the front. From what...
My 225 has a pretty good tap to it right now, it runs great except for that annoying noise. I know that on some engines you can adjust the...
On my 69 there are two small holes on each side of the hood right behind the hood latches about four inces apart. They dont look like someone just...
I just got rid of the spring over and now it is back to stock. I want to put the stock steering back on but ran into a problem. Please bare with...
Could someone tell me what the specs are for the exhaust manifold. I am putting my headers back on and want to be by the book. thanks
Separate names with a comma.