I did this to our '64 CJ5 years ago. Just finishing up doing it to our '52 M38. Had to grind in the knuckles to get the button head to sit flat...
I used a Solex for a while. It hooked right up to the original air horn. The problem was the pump was putting out too much pressure for the...
Could it be Serra Blue? After years in the sun and rain the paint code would be necessary the get the correct color.
On my 64CJ5 I ran a wire from one the sending unit hold down screws to the body, held with a screw. I crimped on eyelets to the wire. Not fancy...
Keep the ones you have and get the 6. Can't have too many Jeeps. Not that there is a competition.
The vise and welder could really be handy on the road side or trail. Good looking Jeep.
In the frame channel below and close to the TK. I put a 1/4 turn valve between the TK and the elect. pump to shut off the gas if I had to work...
I never thought to ask what my hubs were. Now I know, thanks. The center instructions and ID label had come off mine before I got the Jeep.
I put the regulator on my Solex and run it at 2#. Works ok on Eeyore.
Pulling the fender and wheel off would make getting to the area easier. JM2C Tom
Thanks for the link. Looks like it will help warm me up. This is a doable project.
My vacuum cans did not work when I got my '64. I ran choke cables to the levers the cans moved. Very positive control of all the functions....
Where did the up graded blower motor come from? Is the new motor a two or a three speed? The bushings in mine whine for a while as things warm...
Early CJ5 & CJ6 hoods are the same as M38A1 hoods. Jeep made only one hood and it has the cutout for the air intake snorkel that the Army wanted....
I purchased banjo fittings for the master cylinder. They do not stick out far from the MC and allow the lines to be hooked up. I got the banjo...
I have had the AA chain clutch release on our '64 CJ5 for the last 15 years. The cable with a ball on the end goes through a hole in the bell...
Heater duct is crowding that area.
Thank youall for the ideas and help. Harbor Freight opened a store in Rapid City recently and it is just like the flyers they send out. My yf...
I am starting a frame off resto on the body of our '64 CJ5. I am wondering how many rattle cans it might take to paint it? It is blue now and we...
Well obviously I did not get pictures posted. I have never had much luck with posting pictures. The 7.00X15 tires look good on our CJ5 and have...
Separate names with a comma.