[ATTACH] Was wondering if anyone has a better copy of the cutlass hubs decal mines not to great. Thanks Jon
[ATTACH] My latest addition to my tools. Jon
[ATTACH] Hello all, last week I replaced my head gasket due to a coolant leak on the front of my f 134 block, while I was at it I replaced my...
Quick question do you use copper head gasket spray on copper head gasket? thanks Jon
Hello all was wondering if m38a1 door frames the same as early cj5 door frames. Jon
Does anyone have a measurement of a cj2a hand wiper arm and a cj3b or cj5 ventalated windshield hand wiper arm. I have two cj5 hand wipers plus...
[ATTACH] [ATTACH] Hello all, Needing some help getting some info on a old soft top, I've read and looked at lots of pictures and can't say what...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] I have been looking for a dwell tach for awhile, new ones I'm told don't work on 6 volt? I've looked for them...
[ATTACH] [ATTACH] [ATTACH] I finally found a half cab near me. It's ruff all parts are there just some rusted though area's around the rain lip....
[ATTACH] [ATTACH] Went to replace my fuel gauge today as the one I ordered came in and boo it's not going to work unless I cut my center dash...
[ATTACH] [ATTACH] Finished hy-lo pump install on the old cj today. Need to pick up new oil lines and mount control rod. Other than that seems to...
Hello all, I'm looking for pic's of dual pto winches. I have Ramsey's frount pto winch with ramsey single stick dual output pto. I have a line on...
Hello all, I have an issue with my 57 cj5. In mornings doesn't want to start with out a little starting fluild doesn't maker choke on or off....
Hello all,I picked up a Hy lo pump 2 weeks ago and I'm rebuilding it right now, my Question is the double pulley for the generator is the one part...
Hi, Looking for some advice or tricks for pulling rear hubs on a 1957 CJ5, stock dana 44, I have not had any luck with a puller/PB blaster and...
Just finished rebuilding the clutch linkage on my 58 CJ5 T-90. The Kit I got was from Kaiser Willys Kit was good only mod was had to re drill 1...
I finished rebuilding my Ramsey Winch and the cable that was on it was only rated at 1900. I would like to run a synthetic cable vs metal has...
Hi all, Time to get my 6 volt generator rebuilt any one have advice on who does the best rebuild? 57 CJ5 Auto-lite Thanks Jon
Hi all, My CJ ( 57 CJ5 6 Volt) voltage regulator went out on me yesterday. I was going to order a replacement but wondering if it maters that I...
Hi All, I have a delema that doesn't make sense to me. I finished re-doing the wiring for the tailings I now have brinkers and running lights....
Separate names with a comma.